valutazioni - 4, GPA: 3.5 ( )

Produttore : Linear File Size : 798.29 kb File Nome : D-67_D-67F_D-67L_DX-12.pdf Lingua di insegnamento:

APPLY POWER TO THE RECEIVER. BE SURE THE ALARM CONTROL PANEL IS DISARMED OR IN A TEST MODE. 2. TRIGGER EACH TRANSMITTER CODED TO THE RECEIVER. THE RECEIVER RELAY SHOULD CLICK. VERIFY THAT THE PROPER ALARM CONTROL PANEL LOOP IS VIOLATED WHEN THE RECEIVER ACTIVATES. IF THE RECEIVER FAILS TO ACTIVATE, CHECK THE CODE SWITCH SETTINGS AND VERIFY THAT RECEIVER HAS POWER. 3. WITH PORTABLE TRANSMITTERS, OPERATE THEM FROM VARIOUS LOCATIONS TO DETERMINE THE USABLE RADIO RANGE OF THE SYSTEM. THIS WILL HELP TO LOCATE POSSIBLE TROUBLE AREAS WHERE METAL OR OTHER MATERIALS MAY SHIELD THE RECEIVER FROM THE TRANSMITTER. IMPORTANT: ELECTRONIC PRODUCTS ARE NO BETTER THAN THE INSPECTION AND MAINTENANCE THEY RECEIVE OVER TIME. THEREFORE, INSTALLERS SHOULD INSTRUCT THEIR CUSTOMERS TO TEST THIS EQUIPMENT REGULARY, AT LEAST ONCE A WEEK. + AUX OUTPUT COMMON NEGATIVE COMMON LOOP RETURN ZONE 2 INPUT SILVER GOLD END-OF-LINE RESISTOR IN SERIES (IF REQUIRED) COM TYPICAL CONTROL PANEL NORMALLY CLOSED LOOP N/C ZONE 1 INPUT (N/C) ANTENNA + AUX OUTPUT COMMON NEGATIVE COMMON LOOP RETURN ZONE 2 INPUT SILVER GOLD END-OF-LINE RESISTOR IN PARALLEL (IF REQUIRED) TYPICAL CONTROL PANEL ANTENNA ZONE 1 INPUT (N/O) COM N/O RECEIVER NORMALLY OPEN LOOP RELAY OUTPUT CONNECT THE RECEIVER RELAY OUTPUT TERMINALS TO THE DEVICE TO BE TRIGGERED USE EITHER THE NORMALLY OPEN OR THE NORMALLY CLOSED TERMINAL AND THE COMMON TERMINAL IF REQUIRED, CONNECT AN END-OF-LINE RESISTOR AT THE RECEIVER AS SHOWN RELAY RATING: 1 AMP @ 32V AC/DC MAXIMUM RECEIVER POWER CONNECT THE RECEIVER POWER INPUT WIRES TO THE POWER SOURCE CONNECT THE GOLD WIRE TO POSITIVE AND THE SILVER WIRE TO NEGATIVE (IGNORE POLARITY IF CONNECTING TO AN AC POWER SOURCE) RECEIVER POWER REQUIREMENTS: D-67 & DX-12: 11-24 VDC OR 12-16 VAC D-67L & D-67F: 11-14 VDC OR 12 VAC ALL D-67s & DX-12: 15 mA STANDBY, 40 mA RELAY ON ...

Scarica la tua

Per scaricare, digitare 2 cifre :