valutazioni - 1, GPA: 5
(
)
)
|
Facilità d'uso
You should immediately contact your dealer if the subwoofer is damaged . 2. INSTALLATION There are different methods to connect your subwoofer to a HiFi / Home Theater system. In the following text we explain 2 different ways. NOTE! Do not connect the mains cord until all other installation is completed. 2.1 To an amplifier / pre-amplifier with Subwoofer pre-out terminal. Connect the enclosed RCA cord from your amplifiers subwoofer-out terminal to LINE IN on the subwoofer. Use the anclosed Y-adaptor to divide the signal to both inputs. The audio signal is passing through the cords from the subwoofer-out terminal to the built-in amplifier. By using the LOWPASS control, the upper frequnency of the subwoofer can be variably selected from 50Hz - 100 Hz. Note: Connect the satellite speakers to the amplifiers speaker terminals. 2.2 To Speakers output terminal (High level) Connect speaker wires from the speaker terminals of your amplifier to the SPEAKER LEVEL IN of the subwoofer. Carefully check the polarity of the wires (+ to + and - to -). Connect both Left and Right channels. The satellite speakers are connected to SPEAKER OUT on the subwoofer. Again, carefully check the polarity (+ to + etc). In this installation, the satellite speakers HIPASS crossover frequency is automatically set to 100 Hz. If you want the speakers to perform full frequency range, connect them to the normal amplifiers Speaker Output. 4 3. FUNCTIONS Main Power switch (9): To switch the subwoofer amplifier to ON or OFF mode. Make sure it is turned OFF during installation. Standby modes (4): In Power ON mode, SUB FOCUS is equipped with an auto Standby mode cirquit. Set to ON, the subwoofer is constantly ON. In Auto mode the subwoofer will switch to standby approximately 20 minutes after input signal ceased. It will start automatically when signal is received. Turn OFF the Main power switch if the subwoofer will not be used for a longer period of time. Power indicator on amplifier (8): The rear indiactor shows the operation status of the subwoofer amplifier as follows: Light off:OFF Red:Main power ON Power indicator on the front panel: The front panel indiactor shows the operation status of the subwoofer amplifier as follows: Light off:Standby Blue:ON 1 2 3 4 5 6 7 8 9 5 audio pro Volume control (1): The sound level of the subwoofer can be adjusted. Use the volume control carefully, remember that program material may contain very high energy. LowPass (2): The Lowpass crossover frequency can be adjusted variably between 50 and 100Hz. This gives a unique possibility to perfectly match the Subwoofer to your satellite speakers. The lowest frequencies will be reproduced only by the subwoofer. Phase adjustment (3): The placement of the subwoofer can have effect on the phase between subwoofer and satellites. With the phase adjustment the phase can be switched 180 degrees. 10 11 12 audio pro 4. PLACEMENT Your Audio Pro subwoofer is designed to produce music information in the frequency rang...
Questo manuale è adatto anche per i modelli :Altoparlanti - 115V 0502 (178.72 kb)
Altoparlanti - 115V 0502 (178.72 kb)
Altoparlanti - 115V 0502 (178.72 kb)
Altoparlanti - 115V 0502 (178.72 kb)