valutazioni - 4, GPA: 3.5 ( )

Produttore : Altec Lansing File Size : 113.61 kb File Nome : Lingua di insegnamento:

This will also prevent you from "losing" the wire in the ceiling. Before attaching the wire, make sure the speaker wire runs through, not around, the metal mounting bracket. installation preparation Use the supplied template to outline the mounting hole. Cut the mounting hole and remove any debris from the area. Take the necessary steps to keep debris from falling into the back of the speaker. Route the wires from the amplifier to the speaker installation location. Strip about 1/2" of the insulation from the wire conductors. Twist the wire strands of the conductors into neat bundles. Insert the wires into the provided 2-pin plug and tighten the set screws to secure the wires. Connect the speaker plug to the matching 2-pin jack on the crossover board just before final mounting. final installation The speaker is held in place with six mounting clamps that are part of the assembly. When shipped from the factory the clamps are pivoted so they will fit into the mounting hole. When the mounting hole clamp screws are turned, the clamps pivot outward and are then drawn downward until they press against the back of the mounting surface. Insert the speaker/mounting bezel assembly into the mounting hole. Hold the speaker in place in the mounting hole and evenly tighten the four mounting screws to draw the mounting brackets against the backside of the mounting surface. Gradually tighten the screws, moving from one to another, until the speaker is firmly clamped in place. +-+- custom painting • Paint the speaker frame and grill before mounting to the wall; paint grill and frame separately. • Before painting, mask the recessed area of the speaker to completely protect the speaker drivers. • After painting the grill, gently blow through its perforated holes to prevent paint clogging. operation checking the system Listen carefully to each speaker. If you hear buzzing or rattling noises, remove the speaker and check for a speaker wire or other objects touching the speaker assembly. When you are satisfied with the installation press the grills into place. tweeter protector If a speaker sounds "dull", or "lacks "brilliance", you may have activated the tweeter protector. If high power operation causes the tweeter to stop playing, turn down the volume control until normal sound resumes. specifications C500iw C600iw C800iw C900iw Mounting hole 6 1/4" x 9 5/8" 7 3/8" x 10 3/4" 8 3/4” x 12 13/16" 7 3/8" x 16 3/8" Depth from front of wall 2 5/8" 3 1/8" 3 3/8" 3 1/8" Overall dimensions 7 1/2” x 11” 8 3/4" x 12 1/8" 10 1/16" x 14 1/8" 8 11/16" x17 5/8" Power range (RMS watts) 10-75 10-75 10-100 10-100 Impedance 8 ohms 8 ohms 8 ohms 8 ohms Frequency response (Hz) 54-20k 42-20k 36-20k 54-20k Sensitivity 1W/1M (dB) 87dB 88dB 92dB 90dB Woofer 5 1/4" 6 1/2" 8" 2 x 5 1/4" Tweeter 1" dome 1" dome 1" dome 1" dome Crossover frequency (Hz) 2.6k 2.4k 2.4k 2.6k Crossover slope (dB/oct) 12 12 12 12 (Specifications subject to change without notice) warranty information LIMITED FIVE YEAR...

Scarica la tua

Per scaricare, digitare 2 cifre :