Istruzioni per l'uso Kenwood, Modello KDC-W6641U
Produttore : Kenwood File Size : 649.56 kb File Nome :
Lingua di insegnamento:
Vai a scaricare
da questo dispositivo ha anche altre istruzioni :
Facilità d'uso
4 Lower the removal tool toward the bottom, and pull out the unit halfway while pressing towards the inside. Screw (M4 . 8 mm) (commercially available) Accessory2 ¤ • Be careful to avoid injury from the catch pins on the removal tool. 5 Pull the unit all the way out with your hands, being careful not to drop it. English | 29 Troubleshooting Guide Some functions of this unit may be disabled by What might seem to be a malfunction in your unit some settings made on this unit. may just be the result of slight misoperation or miswiring. Before calling service, first check the ! • Cannot set up the subwoofer. following table for possible problems. • Cannot set up the High Pass Filter. • Cannot set up the Fader. General • No Audio control effect on AUX. • Preout is not set to subwoofer. . “MENU” > “SWPRE” of (page 6) • of (page 4) is not set to On. • The Dual zone function is enabled. . (page 18) ? The Touch Sensor Tone does not sound. . The preout jack is being used. . The Touch Sensor Tone cannot be output from the preout jack. ? The illumination flashes when the knob or button is operated. . This is the key illumination effect. . You set this effect in “MENU” > “ILM Effect” of ! ! • Cannot select the output destination of the • Cannot set up the subwoofer phase. (page 6). Setup> (page 18) The Low Pass Filter is set to Through. . (page 18) Tuner source ? Radio reception is poor. . The car antenna is not extended. ! • Cannot set up Display Illumination Control. . Pull the antenna out all the way. (page 17) is not turned off. Disc source • Cannot set up the Power-off timer. ? The specified disc does not play, but another one (page 16) is not set. plays instead. . The specified CD is quite dirty. . Clean the CD, referring to the CD cleaning of the section on (page 3). . The disc is loaded in a different slot from that specified. . Eject the disc magazine and check the number for the specified disc. . The disc is severely scratched. . Try another disc instead. Audio file source ? The sound skips when an Audio file is being played. . The media is scratched or dirty. . Clean the media, referring to the CD cleaning of the section on (page 3). . The recording condition is bad. . Record the media again or use another media. ? Noise is heard when carrying out Folder Search. . Noise may be produced if folders without audio files exist continuously in the playing media. . Do not make folders without audio files. 30 | KDC-W6641U/ KDC-W6541U/ KDC-W6141U/ KDC-W6041U The messages shown below display your systems condition. TOC Error: • No disc has been loaded in the disc magazine. • The CD is quite dirty. The CD is upsidedown. The CD is scratched a lot. Error 05: The disc is unreadable. Error 77: The unit is malfunctioning for some reason. . Press the reset button on the unit. If the “Error 77” code does not disappear, consult your nearest service center. Mecha Error: Something is wrong with the disc magazine. Or the unit is malfunctioning for some reason. . Check the disc magazine. And then press the reset button on the unit. If the “Mecha Error” code does not disappear, consult your nearest service center. IN (Blink): The CD player section is not operating properly. . Reinsert the CD. If the CD cannot be ejected or the display continues to flash even when the CD has been properly reinserted, please switch off the power and consult your nearest service center. Protect: The speaker wire has a short-circuit or touches the chassis of the vehicle, and then the protection function is activated. . Wire or insulate the speaker cable properly and press the reset button. If the “Protect” code does not disappear, consult your nearest service center. Unsupported File: An Audio file is played with a format that this unit can’t support. Copy Protect: Copy Protection: A copy-protected file is played. Read Error: The file system of the connected USB device is broken. . Copy the files and folders for the USB device again. If the error message is still displayed, initialize the USB device or use other USB devices. No Device: The USB device is selected as a source although no USB device is connected. . Change the source to any source other than USB. Connect an USB device, and change the source to USB again. N/A Device: An unsupported USB device is connected. No Music Data/ Error 15: • The connected USB device contains no playable audio file. • Media was played that does not have data recorded that the unit can play. USB ERROR (...
Questo manuale è adatto anche per i modelli :
Unità - KDC-W6041U (649.56 kb)
Unità - KDC-W6141U (649.56 kb)
Unità - KDC-W6541U (649.56 kb)
Scrivi la tua opinione del dispositivo
)
