valutazioni - 1, GPA: 5
(
)
)
|
da questo dispositivo ha anche altre istruzioni :
Facilità d'uso
If you connect this unit in combination with other stereo components, the car circuit they are connected to must be rated higher than the sum of the individual components’ fuse rating. If there are no car circuits rated as high as the unit’s fuse rating, connect the unit directly to the battery. If no car circuits are available for connecting this unit, connect the unit to a car circuit rated higher than the unit’s fuse rating in such a way that if the unit blows its fuse, no other circuits will be cut off. Notes of connection example Notes on the control leads • The power aerial control lead (blue) supplies +12 V DC when you activate the AF (Alternative Frequency) or the TA (Traffic Announcement) function. • A power aerial without a relay box cannot be used with this unit. Warning If you have a power aerial without a relay box, connecting this unit with the supplied power connecting cord 6may damage the aerial. Memory hold connection When the yellow power input lead is connected, power will always be supplied to the memory circuit even when the ignition switch is turned off. Notes on speaker connection • Before connecting the speakers, turn the unit off. • Use speakers with an impedance of 4 to 8 ohms, and with adequate power handling capacities. Otherwise, the speakers may be damaged. • Do not connect the terminals of the speaker system to the car chassis, and do not connect the terminals of the right speaker with those of the left speaker. • Do not attempt to connect the speakers in parallel. • Do not connect any active speakers (with built-in amplifiers) to the speaker terminals of the unit. Doing so may damage the active speakers. Be sure to connect passive speakers to these terminals. Warning when installing in a car without ACC (accessory) position on the ignition key switch Be sure to press (OFF)on the unit for two seconds to turn off the clock display after turned off the engine. When you press (OFF)momentarily, the clock display does not turn off and this causes battery wear. Conexiones Precauciones •Esta unidad ha sido disenada para alimentarse con 12 V CC, negativo a masa, solamente. •Tenga cuidado de no atrapar ningun cable entre algun tornillo y la carroceria del automovil o esta unidad o entre las partes moviles, como por ejemplo los railes del asiento, etc. •Conecte el cable de conexion de alimentacion 6 a la unidad y los altavoces antes de conectarlo al conector de alimentacion auxiliar. •Conecte todos los conductores de puesta a masa a un punto comun. •Conecte el cable amarillo a un circuito libre del automovil de potencia nominal superior a la del fusible de la unidad. Si conecta esta unidad en combinacion con otros componentes estereo, la potencia nominal del circuito del automovil a los que dichos componentes esten conectados debe ser superior a la suma de la potencia nominal del fusible de los componentes. Si no existen circuitos de automovil de potencia nominal tan alta como la del fusible de la unida...