Please read both manuals in their entirety before operating the Dynamic Dolphin Remote or your power chair. This manual is intended as a supplement to the in-service training provided by your authorized provider. If you have any questions or problems regarding the Dynamic Dolphin Remote, please contact your authorized provider. Copyright © 2001 Pride Mobility Products Corporation DoIphin Basic Operation Instructions з _TABLE OF CONTENTS_ INTRODUCTION......................................

CONT2 ENTS Wireless Keyless Entry Installation..... 20 Features……………….. 4 Opening & Closing Force Adjustment… 21 Door Tests……….......... 5 Contact Obstruction Sensing Adjustment. 22 Pre-Assembly Check…………. 5 Mechanical lock Adjustment......... 22 Installation Instructions………… 6 Operational Safety Rules……… 23 Installing Wall Station……….… 8 Operation on Your Opener………. 24 Install Infrared Safety Sensors……. 9 Emergency Release Disconnect...... 26 Wall Station Code Change Maintenance Schedule………...

Check with your garage door manufacturer for their recommendations. Reinforce light weight doors, as illustrated. For wood doors, mount door bracket, using two 1/4”-20 x 2” carriage bolts and 1/4” nuts supplied, on center line of door with middle hole in line with top rollers. For metal doors, mount door bracket, using two 1/4”-20 x 1/2” self drilling screws supplied, on center line of door with middle hole in line with top rollers. Step 7: Installing Light Remove diffuser cover by pressing on b

The light will flash after coming upon an obstruction in the up or down direction to warn you of a problem. It will continue flashing for 4 minutes, and then shut off. If the light begins to flash and the door moves a short distance and then reverses from a wall station button, transmitter or keyless entry, the external safety sensor device is activated or defective. To temporarily override and close door, activate wall station up/down button, keeping button depressed; opener will begin in down

IMPORTANT: You MUST change the Transmitter security code prior to programming the device to the power head unit. WARNING: During programming the garage door may operate. Keep people and objects clear of the moving door to prevent door damage or possible personal injury. Changing the Transmitter Code 1. Press and hold the Transmitter’s large button for approximately 10 seconds until Transmitter’s LED begins to blink rapidly. Release button (LED will turn off). 2. Press and hold the Transmitter’s