valutazioni - 3, GPA: 3
(
)
)
|
Facilità d'uso
5. Unplug appliance from outlet when not in use, before putting on or taking off parts and before cleaning. 6. Avoid contact with moving parts. Keep hands, hair, clothing, as well as spatulas and other utensils out of container to prevent personal injury or damage to the mixer. 7. Do not operate the appliance with a damaged cord or plug, or after the appliance malfunctions, has been dropped or damaged in any manner. Return the appliance to EURO-PROfor examination, repair, electrical or mechanical adjustment. 8. The use of attachments not recommended or sold by EURO- PROmay cause fire, electric shock or injury. Read Instruction Manual Before Use When using electrical appliances, basic safety precautions should always be followed, including the following: 9. Do not use outdoors. 10. Do not let cord hang over edge of table or counter or touch hot surfaces. 11. Container must be properly in place before operating the appliance. 12. Never add ingredients to container while the appliance is operating. 13. DO NOT USE THIS APPLIANCE ON A STOVE. 14. Do not use appliance other than for intended use. 15. Do not operate the drink mixer without the container. Do not use any container other than the one that is supplied with the drink mixer. 16. Unplug drink mixer before cleaning or when not in use. IMPORTANT NOTICE This appliance has a polarized plug (one blade is wider than theother). To reduce the risk of electrical shock, this plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. Do not modify theplug in any way. 1 OPERATING INSTRUCTIONS 1. To clean the blade, fill the container with one (1) cup of warm water. Operate the drink maker on speed “ 1” as previously described in operating instructions. Unplug unit from wall outlet. Dry mixing blades and shaft with a soft dry cloth. 2. Wipe the motor housing with a damp cloth. Make sure that the cloth is not excessively wet and that no moisture enters the vents on the motor housing. 3. Wash the container in warm, soapy water. Do NOTuse abrasive cleaners of any type to clean either the unit or the container. DO NOT IMMERSE THE APPLIANCE IN WATER OR ANY OTHER LIQUID. 1. When preparing milk shakes note that the volume of a milk shake will vary according to the type of milk used. 2. It is important to follow guidelines in the recipes to avoid spillage from the container. 3. Always remember that solids such as ice cream or fruit will increase the volume of the milkshake. 4. The container must always be filled at least to half the distance to the “ MAX” line or the liquid will not reach the blade. 5. When mixing do not fill above the maximum level (8 oz./1 cup/ 250 ml) or liquid will overflow. 6. For best results, all liquid ingredients should be as cold as possible. 7. All syrups and powdered mixes should be added just before mixing to prevent them from sinking to the bottom of the container. 8. The Drink Maker does NOTcrush ice. For best results, use crushed ice if the recipe calls for ice. 4 Cleaning Instructions Hints Warning: Always remove the plug from the wall outlet before cleaning or storing the unit. never immerse the unit, cord or plug in water or any other liquid. GETTING TO KNOW YOUR DRINK MIXER Technical Specifications Voltage: 120V., 60Hz. Power: 70Watts 2 3 OPERATING INSTRUCTIONS Read all the sections of this booklet and follow all the instructions carefully. Before Using for the First Time 1. Remove all promotional labels from the drink maker. Wash the container in hot soapy water and dry thoroughly. 2. Clean the mixing blades and shaft with a damp cloth and dry thoroughly. Using the Drink Mixer 1. Place the drink maker on a level, dry surface. Plug the unit into a 120 volt wall outlet. 2. Make sure that the 2 speed switch is in the center ( 0) “ Off” position (Fig. A). 3. Combine the ingredients in the container. Do not overfill the container beyond the “ MAX” line (Fig. B). 4. Hold the container and place it into the drink maker. Make sure that the top of the container is placed behindthe upper interlocking bracket that supports the container (Fig. C). The base of the container should rest on the bottom bracket pressing on the safety switch. (Fig. D). 5. Switch on the 2- speed electrical switch. 6. Choose speed (l) or (ll) according to the ingredients that you are using. ( Fig. E) . 7. When your drink is ready, press the 2- speed switch to the “ OFF” ( 0) position to stop the unit (Fig. A). 8. Remove the container by lifting it upwards slightly to release it from the bottom bracket and serve. Fig. B 411. Mixing Blades 2. Electrical Switch - ( ll) High Speed, (O) Off, ( l) Low Speed3. Large stainless steel ergonomic container. 4. Bracket with Safety Switch - Unit will not operate unless the container is placed correctly on the switch bracket. 5. Upper interlocking bracket to support the container - always put container lip behind bracket. 6. We...