valutazioni - 0, GPA: 0 ( )

Produttore : Philips File Size : 377.14 kb File Nome : Lingua di insegnamento:

•To clean the CD, wipe in a straight line from the center towards the edge using a soft, lint-free cloth. Do not use cleaning agents as they may damage the disc. • Never write on a CD or attach any stickers to it. Safety information • Place the set on a flat, hard and stable surface so that the system does not tilt. • Where the MAINS plug or an appliance coupler is used as the disconnect device, the disconnect device shall remain readily operable. • Do not expose the set, batteries, CDs to humidity, rain, sand or excessive heat caused by heating equipment or direct sunlight. • The apparatus shall not be exposed to dripping or splashing. • Adequate ventilation with a minimum gap of 15cm (6 inches) between the ventilation holes and surrounding surfaces is necessar y to prevent heat build-up. • Do not cover the ventilation openings with items such as newspapers, table-cloths, curtains, etc. • No objects filled with liquids, such as vases, shall be placed on the apparatus. • No naked flame sources, such as lighted candles, should be placed on the apparatus. • The mechanical par ts of the set contain self- lubricating bearings and must not be oiled or lubricated. •To clean the set, use a dry cloth. Do not use any cleaning agents containing alcohol, ammonia, benzene or abrasives as these may harm the housing. Troubleshooting If a fault occurs, first check the points listed below before taking the set for repair. If you are unable to remedy a problem by following these hints, consult your dealer or ser vice centre. WARNING: Do not open the set as there is a risk of electric shock. Under no circumstances should you try to repair the set yourself, as this will invalidate the guarantee. Problem – Possible cause • Remedy No sound /power – Volume not adjusted • Adjust the VOLUME – Power cord not securely connected • Connect the AC power cord properly – Batteries dead/ incorrectly inserted • Inser t (fresh) batteries correctly – CD contains non-audio files • Press . , § once or more to skip to a CD audio track, instead of the data file. Display does not function properly / No reaction to operation of any of the controls – Electrostatic discharge • Switch off and unplug the set. Reconnect after a few seconds --, Er or 01 indication – No CD inserted • Inser t a CD – CD badly scratched or dirty • Replace/ clean CD, see Maintenance – Laser lens steamed up •Wait until lens has cleared – CD-R/CD-RW is blank or not finalized • Use a finalized CD-R/CD-RW or suitable CD Audio disc only Note: Make sure the CD is not encoded with copyright protection technologies, as some do not conform to the Compact Disc standard. The CD skips tracks – CD damaged or dirty • Replace or clean CD – Program/shuffle is active • Quit program/shuffle mode Note: A CD badly scratch or dirty may result in improper operation. Environmental information All unnecessar y packaging material has been omitted. The packaging can be easily separated into three materials: cardboard, polystyrene and plast...

Scarica la tua

Per scaricare, digitare 2 cifre :