valutazioni - 0, GPA: 0
(
)
)
|
Facilità d'uso
If you contact Philips, you will be asked for the model and serial number of this apparatus. The model number and serial number are on the bottom of the apparatus. Write the numbers here: Model No. __________________________ Serial No. ___________________________ Install batteries B Note . You can use both batteries and AC power as power supply of this apparatus. . Batteries are not supplied with the accessories. 1 Open the bat ter y compar tment. 2 Inser t 6 bat teries (type: R14/ UM2/ C-cells) with correct polarity (+/-) as indicated. 3 Close the batter y compar tment. Connect power C Warning . Risk of product damage! Ensure that the power supply voltage corresponds to the voltage printed on the back or the underside of the apparatus. Risk of electric shock! When you disconnect the AC power, always pull the plug from the socket. Never pull the cord. Note Install the apparatus near the power supply socket and where the power plug can be easily reached. Connect the power cord to: the AC MAINS jack on the unit the power supply socket. Tip To switch the apparatus off completely, disconnect the power cord from the power supply socket. Note To save energy: af ter use, turn off the apparatus. Turn on 1 Push the source selector to CD, FM or MW. Turn off 1 Push the source selector to OFF. 4 Play Play disc 1 Push the source selector to CD. 2 3 Lif t to open the disc compar tment. Inser t a disc with the printed side facing up, then close the disc compar tment. 4 Press to star t play. To pause/resume play, press . To stop play, press . To select another track, press / . To search within a track, press and hold / , then release to resume normal play. For MP3 discs, press ALB +/- to select another album. Listen to the radio Tune to a radio station 1 Push the source selector to FM or MW. 2 Turn TUNING to tune to a station. Tip . Position the antenna as far as possible from T V, VCR or other radiation source. . For optimal reception, fully ex tend and adjust the position of the antenna. Listen to an external device You can listen to an MP3 player through this apparatus. Note When you connect an ex ternal device to MP3 LINK jack, the apparatus switches to MP3 LINK source automatically. 1 Use an MP3 link cable (supplied) to connect MP3 LINK jack (3. 5mm) on this apparatus and the headphone jack on an MP3 player. 5 Play options Adjust volume 1 During play, turn VOLUME to increase/decrease the volume level. Enhance bass 1 During play, adjust DBB to ON/OFF turn on/off dynamic bass enhancement. Select play modes Press MODE repeatedly to select different play modes. . [REP] (repeat) – repeat a track. [REP ALL] (repeat all) - repeat an entire CD/program. [SHUFFLE]" #$ Program tracks You can program a maximum of 20 tracks. For CDs: 1 In CD mode, at the stop position, pressPROG to activate the program mode. 2 Press / to select a track number, then press PROG 3 4Repeat the above steps to program more tracks. Press to play the programmed tracks. » During play, [PROG](program) is displayed. For MP3 discs: 1 In CD mode, at the stop position, press PROG to activate the program mode. 2 Press ALB +/- to select an album. 3 Press / to select a track number, then press PROG 4 Repeat the above steps to program more tracks. 5 Press to play the programmed tracks. » During play, [PROG] (program) is displayed. . To erase the program, press . . To review the program, in the stop position, press PROG. 6 Product information Note Product information is subject to change without prior notice. ! . Disc Laser Type Semiconductor Disc Diameter 12cm/8cm Suppor t Disc CD-DA, CD-R, CD-RW, MP3-CD Audio DAC 24Bits / 44.1kHz Total Harmonic Distor tion <1% Frequency Response 60Hz -16kHz S/N Ratio >62dBA Tuner Tuning Range FM: 87.5-108 MHz; MW: 530-1600 kHz Total Harmonic Distor tion <3% Signal to Noise Ratio >50 dB General Power supply AC: 220 - 240 V, 50 - 60 Hz DC: 9V, 6 x 1. 5V R14/UM2 Operation Power 15 W Consumption Standby Power Consumption &'. Dimensions - Main Unit ( W x H x D) 297 x 112 x 264 mm Weight 1.6 kg Maintenance Clean the cabinet . Use a sof t cloth slightly moistened with a mild detergent solution. Do not use a solution containing alcohol, spirits, ammonia or abrasives. Clean discs When a disc becomes dir ty, clean it with a cleaning cloth. Wipe the disc from the centre out. Do not use solvents such as benzene, thinner, commercially available cleaners, or antistatic spray intended for analogue records. Clean the disc lens Af ter prolonged use, dir t or dust may accumulate at the disc lens. To ensure good play quality, clean the disc lens with Philips CD lens cleaner or any commercially available cleaner. Follow the instructions supplied with cleaner. 7 Troubleshooting Warning Never remove the casing of this apparatus. To keep the warranty valid, never tr y to repair the system yourself. If you encounter problems when using this apparatus, check the following points before requesting ser vice. If the problem ...