valutazioni - 3, GPA: 3.3
(
)
)
|
Facilità d'uso
Interior Cleaning -as Required 1 Disconnect power to the wine cooler / beverage center. 2 Remove racks if desired, see “WINE RACK REMOVAL/INSTALLATION” below. 3 Wipe down the interior with a solution of nonabrasive mild detergent and warm water. 4 Rinse with clear water. 5 Reconnect power to the unit. Wine Rack Removal/Installation 1 Open door fully. 2 Extend wine rack fully. 3 Ball bearing slide features plastic release latches on each side. Push release latches, then pull wine rack out. 4 To reinstall, push ball bearing slides in fully. Slide rack into ball bearing slide ensuring each side engages properly. Maintenance 15 Glass Shelf Removal/Installation Air Filter (Beverage Center Only) Install the static air filter, located in the literature 1 Open door fully. pack, in the proper housing. 2 Method 1 - removal of entire shelf assembly: a. Lift up on front edge and rear portion of shelf. Cantilever brackets will disengage from ladder. b. To reinstall, slide shelf into cabinet ensuring the cantilever brackets engage fully in the proper holes. It may help to extend the glass portion. 3 Method 2 - glass shelf removal: a. Extend shelf fully. b. Ball bearing slide features plastic release latches on each side. Push release latches then pull shelf out. c. To reinstall, push ball bearing slides in fully. Slide shelf rack into ball bearing slide ensuring each side engages properly. 16 Troubleshooting Before You Call for Service If the unit appears to be malfunctioning, read through this manual first. If the problem persists, check the Troubleshooting Guide below. Locate the problem in the guide and refer to the cause and its remedy before calling for service. The problem may be something very simple that can be solved without a service call. Consulting or contracting a qualified service technician may be necessary. WARNING If Service is Required Contact the dealer where you purchased the unit if service is required. State the model and serial number and explain the problem. The model and serial number plate is located on the ceiling of your unit. If you do not know the name of the selling dealer or a local service company, you can check online at or call 1-877-435-3287. ELECTROCUTION HAZARD NEVER attempt to repair or perform maintenance on the unit until the main electrical power has been disconnected. Problem Unit not cold enough. Adjust temperatures (see “Adjusting the Temperature” in the “Start-Up and Temperature Control” section). Possible Cause • Control set too warm. • Light staying on. • Airflow to front grille blocked. • Door gasket not sealing properly. Remedy • Adjust temperature colder. Allow 24 hours for temperature to stabilize. • Turn off manual light control. See “Operation” section. • Airflow must not be obstructed to front grille. See “Installation” section. • Adjust door gasket. Unit too cold. Contents of unit too cold/frozen. Adjust temperatures (see “Adjusting the Temperature” in the “Start-Up and Temperature Control” section). • Control set too cold. • Adjust temperature warmer. Allow 24 hours for temperature to stabilize. No interior light. • Failed LED assembly. • Contact a qualified Electrolux Service Technician. Light will not go out when door is closed. • Manual light control is ON. • Door switch not making contact. • Turn off manual light control. See “Operation” section. • Check for proper door alignment. Alarm(s) will not shut off. • Door is ajar. • Power has failed. • Internal temperature is too high. (Beverage Center only) • Press “Mute Sounds” key to acknowledge alarm. • Ensure door is closed firmly. • Allow 24 hours for temperature to stabilize. Power is not restored after power failure. • Circuit breaker has tripped. • Verify electrical supply. See “Installation” section. Door does not close properly after reversing it. • Door hinges are misaligned. • Door gasket is not sealing properly. • Loosen hinges and re-align door. Retighten hinges. • Turn gasket 180°. See “Door Reversal” section. Warranty Information 17 Major Appliance Warranty Information Your appliance is covered by a one year limited warranty. For one year from your original date of purchase, Electrolux will repair or replace any parts of this appliance that prove to be defective in materials or workmanship when such appliance is installed, used, and maintained in accordance with the provided instructions. In addition, the cabinet liner and sealed refrigeration system (compressor, condenser, evaporator, dryer or tubing) of your appliance is covered by a two through five year limited warranty. During the 2nd through 5th years from your original date of purchase, Electrolux will repair or replace any parts in the cabinet liner and sealed refrigeration system which prove to be defective in materials or workmanship when such appliance is installed, used, and maintained in accordance with the provided instructions. Exclusions This warranty does not cover the following: 1. Products with original ...
Questo manuale è adatto anche per i modelli :Dispenser - EI24WC65GS (975.98 kb)