valutazioni - 1, GPA: 5 ( )

Produttore : DeWalt File Size : 87.37 kb File Nome : a867942f-b660-412f-8007-637531a74e7f.pdf Lingua di insegnamento:

• The label on your tool may include the following symbols. V................volts A....................amperes Hz..............hertz W ..................watts min ............minutes ................alternating current ..........direct current no ..................no load speed ..............Class II Construction ..................earthing terminal ..............safety alert symbol .../min ............revolutions per minute Switch To start tool, depress the trigger switch, shown in Figure 1. To stop tool, release the switch. The variable speed trigger switch permits speed control. The farther the trigger switch is depressed, the higher the speed of the tool. To lock the switch in the on position for continuous operation, depress the trigger switch and push up the locking button. The tool will continue to run. To turn the tool off, from a locked on condition, squeeze and release the trigger once. Before using the tool (each time), be sure that the locking button release mechanism is working freely. Be sure to release the locking mechanism before disconnecting the plug from the power supply. Failure to do so will cause the tool to start immediately the next time it is plugged in. Damage or injury could result.The reversing lever is used to reverse the tool for backing out screws. It is located above the trigger, shown in Figure 1. To reverse the screwdriver, turn it off and push the reversing lever to the right (when viewed from the back of the tool). To position the lever for forward operation, turn the tool off and push the lever to the left. Dead Spindle Action All DEWALT screwdrivers provide a dead output spindle to permit fasteners to be located easily in the driving accessory. Clutches are held apart by light spring pressure permitting the driving clutch to rotate without turning the driven clutch and accessory. When sufficient forward pressure is applied to the unit, the clutches engage and rotate the spindle and accessories. A reversing switch makes it possible to drive or loosen either right or left hand screws. Maintenance CLEANING With the motor running, blow dirt and dust out of all air vents with dry air at least once a week. Wear safety glasses when performing this operation. Exterior plastic parts may be cleaned with a damp cloth and mild detergent. Although these parts are highly solvent resistant, NEVER use solvents. CHANGING CLUTCHES 1. Remove clutch housing by unscrewing (left hand thread). 2. Clamp tool or clutch housing in a resilient clamp.USE CARE, the clutch housing can be easily damaged. 3. Remove round clutch retaining rings with a very small screwdriver (see Figure 2). 4. Install new clutches and new retaining rings. Be careful to assemble the intermediate clutch large end first toward the unit and then the spring. The spring should run against the output clutch. NOTE: If the output spindle slides toward inside of gear case, remove gear case and push output spindle forward to expose retaining ring groove. Reassemble dead spindle spring allowing no more than 1/4" projecting from end of spindle. 5. Relubricate clutches (see Parts Bulletin for DEWALT lubricants identification). LUBRICATION All ball and needle bearings are factory lubricated for the life of the bearing. CLUTCH LUBRI...

Scarica la tua

Per scaricare, digitare 2 cifre :