valutazioni - 3, GPA: 4 ( )

Produttore : Bosch File Size : 1.31 mb File Nome : Lingua di insegnamento:

As the distance from the supply outlet increases, you must use a heavier gauge extension cord. Using extension cords with inadequately sized wire causes a serious drop in voltage, resulting in loss of power and possible tool damage. Refer to the table shown to determine the required minimum wire size. The smaller the gauge number of the wire, the greater the capacity of the cord. For example, a 14 gauge cord can carry a higher current than a 16 gauge cord. When using more than one extension cord to make up the total length, be sure each cord contains at least the minimum wire size required. If you are using one extension cord for more than one tool, add the nameplate amperes and use the sum to determine the required minimum wire size. Guidelines for Using Extension Cords • If you are using an extension cord outdoors, be sure it is marked with the suffix “W-A” (“W” in Canada) to indicate that it is acceptable for outdoor use. • Be sure your extension cord is properly wired and in good electrical condition. Always replace a damaged extension cord or have it repaired by a qualified person before using it. • Protect your extension cords from sharp objects, excessive heat and damp or wet areas. Recommended Minimum Wire Gauge for Extension Cords* Nameplate Extension Cord Length Amperes 25' 50' 75' 100' 150' 0 - 2.0 2.1 - 3.4 3.5 - 5.0 5.1 - 7.0 7.1 - 12.0 12.1 - 16.0 16.1 - 20.0 18 18 18 18 16 14 12 18 18 18 16 14 12 10 18 18 16 14 12 10 18 16 14 12 10 16 14 12 12 * Based on limiting the line voltage drop to five volts at 150% of the rated amperes. READ AND SAVE ALL INSTRUCTIONS FOR FUTURE USE. Symbology Underwriters Laboratories, Inc., United States and Canada Double Insulated Volts Alternating Current No Load revolutions per minute (RPM) Amperes Hertz DANGER! To reduce the risk of injury, always keep hands, rags, clothing, etc. away from moving parts and chips. Do not try to remove chips while the cutter is rotating. Chips sharp and can pull into moving parts. TOOL ASSEMBLY WARNING To reduce the risk of injury,always unplug tool before attachingor removing accessories or makingadjustments. Use only specificallyrecommended accessories. Others may be hazardous. Attaching Feed Handles and Grips Fig. 1 1. Assemble the feed handles and grips to the feed handle hub. Tighten securely. 2. To mount the feed handle to the opposite side, remove the wing screw assembly that secures the hub/pinion assembly. Pull out the hub/pinion assembly and insert on the other side of the housing. Replace and tighten the wing screw assembly. Mounting the Drill on Slide Fig. 2 To provide maximum holding power, mount the motor with the spindle stand. All drills (except 4253-1) be mounted in a reverse drilling close to walls spindle is furthest drill point 1. Select the mounting area that best suits your application. 2. Line up the mounting holes. 3. Slip the lock washers over the mounting screw and insert them through the back of the slide and into the motor mounting ...

Scarica la tua

Per scaricare, digitare 2 cifre :