valutazioni - 2, GPA: 4
(
)
)
|
Facilità d'uso
Additionally these doors are designed for use with the Merit Plus Series, Models CST-38 and CPF-38. Do not alter or modify these door assemblies or a fireplace malfunction or a fire hazard may result. Models 38ABF(BB/BS) have been tested and listed by Omni Test Laboratories, Inc. PLEASE RETAIN THIS MANUAL FOR FUTURE REFERENCE. GENERAL INFORMATION This door assembly consists of a right and left glass panel assembly with the door handles factory mounted. There are no additional parts that are required to install the ABF doors. Fireplaces and gas appliance listed on the front page of this document, have been designed to accept the ABF doors with minimum effort. TOOLS REQUIRED Medium Phillips Screwdriver Hammer 3/8" Open-end wrench US NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE 2 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE INSTALLATION PROCEDURE Using a medium Phillips screwdriver and hammer, drive the ash lip end down and away from the holes in the lower frame (Figure 1 ). Both right and left side holes must be clear (Figure 2 ). All BCF, BRF, CST-38 and CPF-38 Series fireplaces have these lower and upper door mounting holes provided in the lower and upper front frame. Figure 2 Screw may be Removed to Provide Room to Adjust Ash Lip Ash Lip Step 2. Lift and swing the lower corner of the door over the hole in the lower frame and engage the shorter hinge pin into this hole (Figures 5 and 6 ). Figure 5 Hinge Pin Roller Pin Upper Door Guide Track Figure 1 Figure 4 Figure 3 Pivot Pin Roller Pin Lower Hinge Pin Figure 6 Step 3. Repeat this procedure for the opposite door assembly. ADJUSTMENT FOR DOOR ALIGNMENT The doors are properly adjusted when the top door trim is in a straight, level line and the gap between the doors is even at the top and bottom. If adjustments are required, grasp the door handle and loosen the lower door hinge pin using a 3/8" open end wrench*. Slide the door panel on the hinge pin until the gap between the upper door trim and upper frame is even. Retighten the lower door hinge pin*. Repeat this procedure for the opposite door if needed. *Note: Upper door hinge pins can also be loosened for adjustment purposes; however, it is easier to loosen lower pins. GENERAL OPERATING PRECAUTIONS AND INSTRUCTIONS CAUTION: THESE GLASS DOORS ARE LISTED ONLY FOR USE WITH THE SUPERIOR FIREPLACE OR APPLIANCE MODELS SHOWN. USE ON ANY OTHER FIREPLACE OR APPLIANCE MAY CONSTITUTE A POTENTIAL FIRE HAZARD. • Avoid building extremely large fires as the tempered glass could become damaged. • Use fireplace tools carefully to avoid striking the glass. Step 1. Starting with either the right or left door assembly. Engage the hinge pin into the upper frame hole. The roller pin must be positioned within the upper door guide track (Figures 3 and 4 ). Pivot Point Lower Frame • • Assure wood and embers are well within the confines of the grate area and well away from the glass doors. • Keep wire mesh screens closed during fireplace use. • Keep glass doors closed at n...
Questo manuale è adatto anche per i modelli :Porte e finestre - 38ABF-BS (77.65 kb)
Porte e finestre - 38ABF (77.65 kb)