valutazioni - 3, GPA: 4.3 ( )

Produttore : Lennox Hearth File Size : 57.33 kb File Nome : Lingua di insegnamento:

Step 2. Position the frame in the fireplace opening on top of the door support bracket, centering left and right. Mark the fireplace at each hole in the side panels. Note:The frame is provided with two sets of holes allowing for near "Flush Face" installation and "Protruding" installations that may be particularly useful in certain finish applications. In most cases the door frame will not install completely flush with the appliance front face. The frame will usually protrude from the opening approximately an 1/8 of an inch. NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE Screw Support Bracket Door Screw *Note: This is an air inlet. DO NOT cover this space with any materials. * Detail Screw Support Bracket Door Screw *Note: This is an air inlet. DO NOT cover this space with any materials. * Detail Step 3. Remove the frame from the fireplace and drill a pilot hole 5/64" diameter at each of the four marks. Re-position the frame into the fireplace centering left and right. Insert the screws through the side panel holes and screw them into the pilot holes just drilled. Model Estate 48 Fireplaces Note:The Center Wedge Clip located inside the track in the center of the door frame indicates the bottom of the frame. It is important that the frame be installed with the correct side up to insure smooth operation of the doors. Step 1. Lay the frame face down on a clean, soft surface to avoid scratching the brass. Note the two Phillips Screws mounted to Tinnerman nuts on each of the side panels, loosen these screws to allow adjustment of the position of these Tinnerman nuts. Position the nuts to align with the round holes on the Estate 48 attachment brackets (seeFigure 2). Do Not attach brackets to the door at this time. Attachment Bracket Step 2. Locate the Phillips heads of the screws just around the back of the firebox opening at both the right and left sides. The slots of the Estate 48 attachment brackets will engage these screws and be secured in place by their heads. Back these screws out about an 1/8 of an inch. Step 3. Position the Estate 48 attachment bracket within the fireplace opening with their black faces forward and their slots engaged around the screws backed out in the previous step. Snug up two (2) screws on each side, DO NOT TIGHTEN. The attachment brackets must be allowed to move in the following step. Step 4. Remove the Phillips screw from the Tinnerman nuts in the door frame assembly. Position the frame within the opening and align the Tinnerman nuts with the four round holes of the attachment brackets, two (2) on each side. Secure the frame to the brackets with the four (4) screws, DO NOT TIGHTEN. Step 5. Center the door frame within the opening, left to right and push door frame up to the top of the opening as far as it will go. Carefully tighten all screws, making sure they are not overtightened. Do Not obstruct the gaps to the left and right of the frame. These spaces are designed for inlet air to enter the fire box. Installing the Door...

Scarica la tua

Per scaricare, digitare 2 cifre :