valutazioni - 2, GPA: 4.5 ( )

Produttore : Echo File Size : 127.76 kb File Nome : 99944200416esf_013003.pdf Lingua di insegnamento:

NOTE Use of a harness (not included) and this kit will allow use of metal or nylon grass/weed blades. All other metal blade usage requires a "U" Handle Kit and restrictive harness. NOTE The Barrier Bar is used to restrict rearward movement of the unit. For heavy-duty or extended use, U-handles should be used. See your Echo dealer or Trimmer/Brush Cutter Safety Manual for details regarding U-Handles. If you have additional questions, contact your Echo Service Dealer, or call Echo directly at 1-800-673-1558. CONTENTS: 1, Upper Plate, 20 mm 3, 5mm x 15mm screws (shield mount) 1, Lower Plate 2, 5mm x 8mm screws (bracket to shield) 1, Harness Clamp w/spacer 4, 5mm nuts 1, Harness Ring 4, 5mm lockwashers 1, Barrier Bar 1, 5 mm x 18 mm Bolt (Harness Clamp) 1, Metal shield 1, M10 x 1.25 L.H. Nut 1, Bracket INSTALL METAL SHIELD If necessary, remove nylon head, plastic shield, and 38 mm upper plate. 1. Loosely attach bracket (A) to shield (B) and attach to bottom of gear housing (C) with screws and nuts provided. 2. Install nuts and lockwashers on screws where indicated and tighten all hardware. WARNING DANGER The type of Blade used MUST be matched to the type and size of material cut. An improper or dull blade can cause serious personal injury. Blades MUST be sharp. Dull blades increase the chance of kick-out and injury to yourself and bystanders. INSTALL OPTIONAL BLADE Metal or Plastic 1. Install upper plate (D) with 20 mm diameter pilot on splined shaft. Pilot must match blade center hole for proper fit. 2. Place blade (E) over upper plate pilot and install the "lower plate" (F) and L.H. nut (G). Tri-Cut blade (H) is installed with glide cup (J). 3. Insert locking tool (K) through hole in upper plate and notch in gear housing (C) to prevent splined shaft from turning, tighten nut (G) and secure with a split pin (L). C A B H K D E J F G L K D 20 2020202020 E F G L IMPORTANT Never reuse a cotter pin - install a new cotter pin each time a blade is installed or replaced. 4. Remove locking tool. X7502233600 X750005530 01/03 INSTALL HARNESS CLAMP NOTE Some models require installation of harness clamp. If your unit does not have a clamp follow these directions. 1. Remove shield and gear housing as an assembly. a. Loosen two (2) screws (A) that clamp the gear housing to the shaft. b. Remove locating screw (B) found at the top of the gear housing. c. Pull shield and gear housing assembly from the drive shaft assembly. NOTE Prevent the flexible drive cable from sliding from the drive shaft housing. If cable does slide free, clean dirt from cable and re- lubricate with lithium based grease prior to re-assembly. 2. Remove front handle. a. Remove four (4) screws and nuts and back plate from handle. b. Remove handle. 3. Install clamp. a. Slightly spread clamp and carefully slide up drive shaft. b. Install harness ring using spacer and 5 x 18 mm bolt. c. Put on harness and attach unit to harness. Slide harness clamp up or down until unit balances with head approximate...

Scarica la tua

Per scaricare, digitare 2 cifre :