valutazioni - 2, GPA: 4
(
)
)
|
Facilità d'uso
3. Drain the oil from the warm engine. Fill the engine crankcase with new oil. 4. Remove the spark plug from the cylinder. Pour one ounce of oil into the cylinder. Slowly pull the recoil-start grip so that the oil will protect the cylinder. Install a new spark plug in the cylinder. 5. Clean the dirt and debris from the cylinder cooling fins and the engine housing. 6. Clean the bottom of the mower housing. 7. Completely clean the mower to protect the paint. 8. Put the unit in a building that has good ventilation. F-050414L 17 TROUBLE SHOOTING CHART The Engine will not start. 1. Make sure the fuel tank is filled with clean gasoline. Do not use old gasoline. 2. On a cold engine, push the primer button (optional on some models). For the number of times required to push the primer button, see the engine manufacturer’s instructions. 3. Make sure the wire for the spark plug is connected to the spark plug. 4. Adjust the Carburetor. See the “Engine Instruction Book”. 5. There is too much gasoline in the engine cylinder. Remove and dry the spark plug. Pull the re- coil-start grip several times. Install the spark plug. Connect the wire to the spark plug. Start the engine. 6. The engine is difficult to start in heavy or high grass. Move the mower to a clean dry surface. 7. Make sure the engine stop lever is in the operating position. 8. Make sure the fuel valve is in the ON position. See the “Engine Instruction Book”. 9. On Electric Start models, charge the battery. The Engine will not stop. 1. Release the engine stop lever. 2. Check the engine stop cable. Replace the cable if bent or damaged. The Engine performance is bad. 1. Check the height of cut settings. Raise the height of cut if the grass is high. 2. Check the bottom of the blade housing. Clean the blade housing of grass and other debris. 3. Check the wire to the spark plug. Make sure the wire is connected. 4. Clean the engine cooling fins of grass and other debris. 5. Check the carburetor adjustments. See the “Engine Instruction Book”. 6. Check the spark plug gap. Set the spark plug gap at 0.030”. 7. Check the amount of oil in the engine. Fill with oil if necessary. 8. Check the engine air cleaner. See the “Engine Instruction Book”. 9. The gasoline is bad. Drain and clean the fuel tank. Fill the fuel tank with clean gasoline. Excessive Vibration. 1. Remove the blade. Check the blade and balance if necessary. See the blade maintenance instructions. 2. Check for a bent or broken blade. A DAMAGED BLADE IS DANGEROUS AND MUST BE REPLACED. 3. Check the blade adapter. REPLACE A BROKEN BLADE ADAPTER. 4. If the vibration continues, take the mower to an Authorized Service Center. The grass will not discharge correctly. 1. Clean the bottom of the mower housing. 2. Check for a badly worn blade. Remove and sharpen the blade. For safety, replace the blade every two years with a factory replacement blade. The grass is not cut even. 1. Check the height adjustment at each wheel. The height adjustment must be the same for each wheel. 2. Make sure the blade is sharp. 3. Check for a bent or broken blade. A DAMAGED BLADE IS DANGEROUS AND MUST BE REPLACED. 4. Check for a broken blade adapter. REPLACE A BROKEN BLADE ADAPTER. F-050414L 18 F-050414L 19 HANDLE - BRIGGS & STRATTON MODELS 1 2 13 16 12 7 4 3 15 KEY KEY NO. DESCRIPTION PART NO. NO. DESCRIPTION PART NO. 1 Handle, Upper (Black) 1101556E701 7 Locknut 15x116 Handle, Upper (Gray) 1101556E724 12 Guide, Rope 071530 2 Handle, Lower (Black) Handle, Lower (Gray) 1102087E701 1102087E724 13 Engine Stop Lever 1101964E701 3 Bolt 002x77 15 Fastener, Cable 1101353 4 Knob, Plastic 071294 16 Engine Stop Cable * Engine Stop Cable # 1102094 1102072 * Used on Briggs & Stratton Classic, Sprint, Quattro, Q-Style and QS-Style engines. # Used on Briggs & Stratton Quantum engines. F-050414L 20 HANDLE - TECUMSEH ENGINE MODELS 1 2 8 9 8 6 7 4 10 KEY KEY NO. DESCRIPTION PART NO. NO. DESCRIPTION PART NO. 1 2 Handle, Upper (Black) Handle, Upper (Gray) Handle, Lower (Black) Handle, Lower (Gray) 1101556E701 1101556E724 071137E701 071137E724 6 7 8 Engine Stop Cable Guide, Rope Locknut 1102041 071530 15x116 4 Lever, Stop 1101964E700 9 Bolt 002x77 5 Knob, Plastic 071294 10 Fastener, Cable 1101353 F-050414L 21 MODELS WITH STANDARD WHEELS F-050414L 22 1 2 3 5 6 4 7 9 5 6 12 13 15 14 16 17 18 19 20 21 22 23 24 11 28 27 10 10 MODELS WITH STANDARD WHEELS KEY NO. DESCRIPTION PART NO. 1 Engine ‡ -----2 Housing 776022 3 Height Adjuster, Left Rear (8” Wheels) 672641 Height Adjuster, Left Rear (7” Wheels) 672637 4 Knob 071495 5 Wheel and Tire # -----6 Locknut, Flange 015x84 7 Bolt, Carriage 002x81 9 Bolt, Engine 0025x6 10 Nut 015x68 11 Height Adjuster, Left Front (8” Wheels) 672601 Height Adjuster, Left Front (7” Wheels) 672635 12 Washer, Belleville 17x137 13 Washer 17x124 14 Bolt, Hex 01x142 15 Blade, Side Discharge 042225E701 16 Adapter, Blade 071056 17 Height Adjuster, Right Front (8” Wheels) 672600 Height Adjuster, Right Front (7” Wheels) 672634 18 Height Adjuster...
Questo manuale è adatto anche per i modelli :falciatrici - 22 (544.46 kb)
falciatrici - 22 (544.46 kb)
falciatrici - 22 (544.46 kb)
falciatrici - 22 (544.46 kb)