valutazioni - 5, GPA: 3.6
(
)
)
|
Facilità d'uso
[1] Place engine level and clean around oil fill area. [2] Remove oil fill cap or dipstick. Low Oil Fill OIL LEVEL [3] Pour oil slowly. Fill to point of overflowing. [4] Replace and tighten oil fill cap. OIL CHECKING AND ADDING OIL Low Oil Fill with Dipstick [1] Remove dipstick and wipe with clean cloth. [2] FULL OIL LEVEL Insert dipstick, but DO NOT TIGHTEN. Remove and check oil level. [3] Pour oil slowly. Fill to FULL mark on dipstick. Replace and tighten dipstick. FUEL TYPE OF FUEL TO USE • Use clean, fresh, regular unleaded gasoline with a minimum of 85 octane. Fresh fuel prevents gum from forming in the fuel system or on essential carburetor parts. Purchase fuel in quantity that can be used within 30 days. • Do not use gasoline which contains Methanol. • Do not mix oil with gasoline. • For engine protection use Briggs & Stratton Gasoline Additive available from your Authorized Briggs & Stratton Dealer (P/N 5041 or single use pouch). • This engine is certified to operate on gasoline. Exhaust Emission Control System: EM (Engine Modifications). CAUTION: Some fuels, called oxygenated or reformulated gasoline, are gasoline blended with alcohols or ethers. Excessive amounts of these blends can damage the fuel system or cause performance problems. If any undesirable operating symptoms occur, use gasoline with a lower percentage of alcohol or ether. ADDING FUEL WARNING • Turn engine OFF and let engine cool at least 2 minutes before removing gas cap. • Fill fuel tank outdoors or in well-ventilated area. • Keep gasoline away from sparks, open flames, pilot lights, heat, and other ignition sources. • If fuel spills, wait until it evaporates before starting engine. [1] Remove cap. Fill tank to approximately 1-1/2 inches below top of neck to allow for fuel expansion. Be careful not to overfill. Briggs & Stratton Smart-fill. fuel can fills to the correct level and automatically shuts off, reducing spills and emissions. [2] Replace cap before starting. Fuel Fill STARTING STARTING AND OPERATING TIPS ¦Store and fuel equipment in level position. ¦Use fresh fuel. (See Fuel.) ¦Use correct type of oil for expected starting temperature. (See Oil.) ¦Remove external equipment/engine loads. (See equipment operating instructions.) ¦Periodically remove any debris buildup from the machine (See Maintenance.) ¦After engine has started, let it warm up several seconds to several minutes, depending on outside temperature. ¦For maximum performance and life, operate engine with choke in RUN and throttle in FAST. 8 STARTING AND STOPPING STARTING AND STOPPING WARNING • Do not use pressurized starting fluids. • Vapors are flammable. CAUTION: Some engines may be equipped with OIL GARD®. The OIL GARD® is intended to warn the operator that the engine is low on oil. Always check oil level before starting. Engine damage may occur if the oil level is not properly maintained and will void warranty coverage. If the engine will not start, has stopped running and/or a light flickers in the stop switch, add oil (see instructions). REWIND (MANUAL) STARTER TO START ENGINE [1] Check oil level (see p. 7). [2] Turn fuel shut-off valve (if equipped) 1/4 turn to OPEN. [3] Push choke lever to CHOKE position. [4] Move throttle (if equipped) to FAST. Operate engine with throttle in FAST. Fuel shut-off Choke OIL LEVEL FULL OPEN POSITION [5] Push rocker switch (if equipped) to ON. [6] Grasp rope handle. Pull slowly until resistance is felt, then pull rapidly to start engine and avoid kickback. [7] Let engine warm up. If choke equipped: Slowly adjust toward RUN position. Wait until engine runs smoothly before each choke adjustment. WARNING TO STOP ENGINE [1] Move throttle (if equipped) to SLOW, then to STOP. Fuel shut-off [2] Push rocker switch (if equipped) to OFF. [3] Close fuel shut-off valve (if equipped). CAUTION: Do not stop engine by moving choke control to CHOKE. Backfire, fire or engine damage could occur. 9 STARTING AND STOPPING STARTING AND STOPPING ELECTRIC (KEY) STARTER (if equipped) TO START ENGINE [1] Check oil level (see p. 7). OIL LEVEL FULL [2] Turn fuel shut-off valve (if equipped) 1/4 turn to OPEN. [3] Push choke lever to CHOKE position. Fuel shut-off Choke OPEN POSITION [4] Move throttle (if equipped) to FAST. Operate engine with throttle in FAST. [7] Let engine warm up. If choke equipped: Slowly adjust toward RUN position. Wait until engine runs smoothly before each choke adjustment. [5] Push rocker switch (if equipped) to ON. [6] Insert key and turn to START. CAUTION: To prolong starter life, use short starting cycles (5 seconds maximum, then wait one minute). Follow equipment manufacturer’s recommendations for charging battery. TO STOP ENGINE [1] Move throttle (if equipped) to SLOW. [3] Push rocker switch (if equipped) to OFF. Fuel shut-off [2] Turn key to OFF. Remove key [4] Close fuel shut-off valve and store out of reach of children. (if equipped). 10 MAINTENANCE MAINTENANCE MAINTENANCE Regular maintenance will improve the performance a...
Questo manuale è adatto anche per i modelli :falciatrici - 120000 (644.79 kb)