13 INSTALLATION INSTRUCTIONS Built-in Outdoor Side Burner Installation ¦ Unpack side burner. Remove all packaging materials and remove side burner from carton. ¦ Place side burner into outdoor enclosure, but leave enough room in back to connect to gas supply and electrical single prong plug-in. Install Tank Tray for 20 lb LP Gas Fuel Tank For Models Equipped for Use with a 20 lb LP Tank 1. Position the tank tray for 20lb LP gas fuel tank in the island cabinet. 2. Square the tank tray mounting br

For outdoor side burners using a 20 lb LP gas fuel tank: Slowly open the tank valve. NOTE: If flow limiting device activates, your side burner may not light. If your side burner does light, the flames will be low and will not heat properly. Turn 20 lb LP gas fuel tank valve and all control knobs off and wait 30 seconds. After shutting off the 20 lb LP gas fuel tank, very slowly open tank valve and wait 5 seconds before lighting. 2. For outdoor side burners using gas supply source other than 20 l

Read and follow the instructions provided with any tools listed here. 20 lb LP Gas Models Tools Needed ¦ Tape measure ¦ Wrench or pliers ¦ Small, flat-blade screwdriver ¦ Pipe wrench ¦ Flat-blade screwdriver ¦ Scissors or cutting pliers (to remove tiedowns) ¦ #2 and #3 Phillips screwdriver ¦ Noncorrosive leak- ¦ Level detection solution Parts Supplied ¦ Gas pressure regulator/hose assembly set for 11" WCP LP gas (attached to manifold) ¦ 1 single-prong plug/5,000 mAmp transformer assembly ¦ Conve

® IMPORTANT: Installer: Leave Installation Instructions with the homeowner. Homeowner: Keep Installation Instructions for future reference. Read and save these instructions for local electrical inspector’s use. Write the model and serial numbers in space provided below before installing or using outdoor Side Burner. The numbers are stamped on the identification label, located on bottom flange of the control panel. they are also located on the model/serial number plate, located on the side panel.