valutazioni - 4, GPA: 3.5
(
)
)
|
Facilità d'uso
. GB GB . . . . . Positioning and levelling Electrical connection Table of characteristics " . Overall view Control panel $ %& . Setting the time Using the oven Cooking modes for Multi-function (1rst Oven) Cooking modes for conventional-function (2nd Oven) Practical cooking advice Oven cooking advice table ( ) *+. % +. General safety Disposal Respecting and conserving the environment %) +. Switching the appliance off Cleaning the appliance Replacing the oven light bulb . Assistance . ,- ! Before operating your new appliance please read this instruction booklet carefully. It contains important information concerning the safe installation and operation of the appliance. ! Please keep these operating instructions for future reference. Make sure that the instructions are kept with the appliance if it is sold, given away or moved. ! The appliance must be installed by a qualified professional according to the instructions provided. ! Any necessary adjustment or maintenance must be performed after the cooker has been disconnected from the electricity supply. .. ! It is possible to install the appliance alongside cupboards whose height does not exceed that of the hob surface. ! Make sure that the wall in contact with the back of the appliance is made from a non-flammable, heat- resistant material (T 90°C). To install the appliance correctly: • Place it in the kitchen, the dining room or the bed- sit (not in the bathroom). • If the top of the hob is higher than the cupboards, the appliance must be installed at least 600 mm away from them. HOOD 900Min. mm. 420Min.min. 650 mm. with hoodmin. 700 mm. without hoodmm. 420Min. mm. • If the cooker is installed underneath a wall cabinet, there must be a minimum distance of 420 mm between this cabinet and the top of the hob. This distance should be increased to 700 mm if the wall cabinets are flammable (see figure). • Do not position blinds behind the cooker or less than 200 mm away from its sides. • Any hoods must be installed according to the instructions listed in the relevant operating manual. /.. If it is necessary to level the appliance, screw the adjustable feet into the places provided on each corner of the base of the cooker (see figure). The legs* fit into the slots on the underside of the base of the cooker. . WARNING – THIS APPLIANCE MUST BE EARTHED. The appliance is designed to work with alternating current at the supply voltage and frequency indicated on the rating plate (situated on the rear part of the appliance and on the last page of the instruction booklet) or at the end of the instruction booklet. Make sure that the local supply voltage corresponds to the voltage indicated on the rating plate. To connect directly to the mains supply, a double- pole switch with a contact separation of at least 3 mm suitable for the load and complying with current standards and regulations, must be fitted between the appliance and the mains supply outlet. The yellow-green earth wire must not be interrupted by the switch. The supply cable must be in such a position that no part of it can reach a temperature of 50 °C above room temperature. Do not use adapters or shunts as they could cause heating or burning. Before connecting to the power supply, make sure that: • the limiter valve and the domestic system can withstand the load from the appliance (see rating plate); • the supply system is efficiently earthed according to standards and laws in force; • the socket or double-pole switch are easily accessible when the appliance is installed. FAILURE TO OBSERVE THE ACCIDENTPREVENTION REGULATIONS RELIEVES THE MANUFACTURER OF ALL LIABILITY. Important: the wires in the mains lead are coloured in accordance with the following code: Green & Yellow - Earth Blue - Neutral Brown - Live As the colours of the wires in the mains lead may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows: Connect the Green & Yellow wire to terminal marked ,- “E” or or coloured Green or Green & Yellow. Connect the Brown wire to the terminal marked “L” or coloured Red. Connect the Blue wire to the terminal marked “N” or coloured Black. Replacing the cable Use a rubber cable of the type H07RN-F with a suitable cross section 3 x 6 mm.. The yellow-green earth wire must be 2-3 cm longer than the other wires. TECHNICAL DATA (1st Oven ) Oven dimensions H:34;W:38;D:44 cm Volume 54 Lt Voltage and frequency see data plate ENERGY LABEL Directive 2002/40/EC on the label of electric ovens. Regulation EN 50304 Energy consumption for Natural convection – heating mode: Traditional mode; Declared energy consumption for Forced convection Class – heating mode: Multi cooking Mode. EC Directives: 2006/95/EEC dated 12/12/06 (Low Voltage) and subsequent amendments - 89/336/EEC dated 03/05/89 (Electromagnetic Compatibility) and subsequent amendments - 93/68/EEC dated 22/07/93 and subsequent amendments 2002/ 96/EC. TECHNICAL DATA (2nd Oven) Dimension...