valutazioni - , GPA: ( )

Istruzioni per l'uso Thermo Products, Modello CHX1-100

Produttore : Thermo Products
File Size : 1.02 mb
File Nome :

Lingua di insegnamento:

Il documento viene caricato, si prega di attendere

Scarica la tua primo

Il documento viene caricato, si prega di attendere

Scarica la tua primo

Go to the next step if you don’t smell gas. 7. Turn gas control knob counterclockwise to “ON” position. (For gas valves with a switch, move the switch to the “ON” position). 8. Replace front door. 9. Turn on electric power to the appliance. 10. Set thermostat to desired setting. 11. Follow the instructions “To Turn Off Gas To Appliance” and call a qualified heating contractor or gas supplier if the appliance will not operate. C. SHUTDOWN PROCEDURE TO TURN OFF GAS TO FURNACE: 1. Set the thermostat to lowest setting. 2. Turn off the electric power to the appliance if service is to be performed. 3. Remove front door. 4. Turn the knob on the combination valve to the full OFF position. 5. Replace front door. IV. HOMEOWNER/USER MAINTENANCE INSTRUCTIONS (ROUTINE MAINTENANCE) The following maintenance procedures should be performed by the homeowner/user during the heating season. : Homeowners attempting maintenance other than that covered as homeowner/user maintenance may cause conditions which could result in personal injury or property damage. : Shut off the power to the furnace before removing blower compartment door to avoid injury from moving parts. A. ANNUAL INSPECTION The homeowner must have this furnace professionally inspected at the beginning of each heating season by a qualified heating contractor to ensure proper operation. 11 All installations and services must be performed by qualified service personnel. NOTICE: This furnace has been shipped from the factory with a permanently lubricated circulating air blower motor. Any maintenance to this blower motor is to be performed only by a qualified heating contractor. B. FILTER MAINTENANCE PROCEDURE 1. The return air filter provided with this unit is a re-useable type filter. This filter should be inspected monthly. When dirty, the filter must be cleaned or replaced, if necessary, to assure proper furnace operation. Follow the cleaning, removal and replacement procedure below. NOTICE: If the furnace is installed in a home or structure being remodeled, dust levels may be much higher than normal The filter must be inspected daily and cleaned as needed until dusty conditions have been eliminated. Any replacement motors not obtained through Thermo Products should be lubricated according to the motor name plate. : This furnace is not to be used for temporary heating of buildings or structures under construction. UPFLOW FURNACE (CHX1/CHB1/MHA1) The filter rack or drop chute will be located between the return air plenum and the return air opening of the furnace (See Figure 3). Slide dirty filter out of the filter rack. Clean the filter by vacuuming, rinsing with tap water, hosing or dipping in an ordinary detergent solution. Replace the completely dry filter in the rack. The mesh side of the filter must be installed towards the furnace after cleaning. COUNTERFLOW FURNACE (CDX1/CDB1/MDA1) TURN OFF POWER TO FURNACE. The filter rack will be located on top of the furnace inside the return air duct using eith...