Log:
valutazioni - 3, GPA: 4 ( )

Istruzioni per l'uso Enerco, Modello MH12T

Produttore : Enerco
File Size : 693.48 kb
File Nome : 1726.pdf
Lingua di insegnamento: en
Vai a scaricare



Facilità d'uso


This heater must be located at least 24” above the floor level when in use. Never operate the heater when sleeping. C. WARNING: Never direct the heat output of this heater toward any propane tank within 20 feet. BTU/HR. RATING NORMAL CLEARANCES TO COMBUSTIBLES MODEL NO. GAS PROPANE OPERATING PROCEDURE FROM C.L. OF HTR. TO FLOOR SIDES REAR CEILING MH12T and MH12TS 14,000 Vertical 24” 30" 30" 30” Figure 4 5. ASSEMBLY PROCEDURE A. Make sure the regulator knob on the heater is “off” by turning knob clockwise to the “OFF” position. B. Carefully screw POL nut directly into bulk 20 lb. propane cylinder, counterclockwise. REMEMBER – This is a left hand thread – see Figure 2. Make sure the heater is in a vertical upright position and directed away from the collar of the bulk tank. Use a 7/8” open end wrench to tighten the POL fitting – left hand thread – see Fig. 2. Mr. Heater | Gas-Fired Infra-Red Portable Heater 5 Operating Instructions and Owner’s Manual 6. 6. A. Before attempting to light the heater, check all fittings and connections with a soap solution. NEVER USE A MATCH TO CHECK FOR LEAKS. Should a gas leak occur, do not attempt to repair or use heater. Return the heater to your dealer or the address given on back page. B. Fuel – This heater must be used only with a vapor withdrawal LP gas bulk cylinder. THE BULK TANK MUST BE EQUIPPED WITH A STANDARD POL VALVE. WARNING USE HD.5 PROPANE GAS ONLY. DO NOT USE ANY OTHER TYPE FUEL. SEE YOUR PROPANE DEALER IF YOU HAVE ANY QUESTIONS REGARDING FUEL. C. Turn the heater’s “Hi-Med-Lo-Off” regulator knob to “Med” (counterclockwise). D. To light MH12T, place a lit match across the mesh screen where you see “light here” on reflector. (See Fig. 5) THEN push in valve button on Safety Shutoff Valve. After the heater is lit, continue to hold valve button in for 30 seconds, then release the button slowly. CAUTION: DO NOT PUSH IN VALVE BUTTON BEFORE INSERTING LIT MATCH. E. To light MH12TS, press “Sparklite” ignitor Safety Shutoff Valve button at the same time. (See Fig 5a) Prior to pressing "Sparklite" igniter. After the heater is lit, continue to hold valve button in for 30 seconds, then release the button slowly. F. If burner does not light within 30 seconds, turn the heater’s regulator knob to “off” (clockwise) and allow at least five minutes for gas to dissipate before attempting to relight. G. NOTE: Should the orifice become clogged as indicated by low volume of gas when operating on “Hi” with a full cylinder, or should the heater fail to operate properly for any reason, return the heater to the dealer or the address given on back page for repair or replacement. DO NOT ATTEMPT TO REPAIR OR TAMPER WITH HEATER. H. Adjust heat output by turning knob to desired position. I. COOKING: DO NOT USE THIS HEATER FOR COOKING. Figure 5 MODEL MH12T 7. SHUTDOWN AND STORAGE INSTRUCTIONS A. The bulk propane tank “on-off” valve should ALWAYS be completely turned “OFF” when the heater is not in use. B. When shutting off the heater, turn the regulator knob on the heater to “OFF” (clockwise). (See Figure 5 and 5a) C. CAUTION: After turning unit off, heater will remain extremely hot. Allow at least 15 minutes for cooling before handling and storing. Detach heater from bulk tank before handling and storage. REMEMBER – POL fitting is a left-hand thread. D. HEATER STORAGE: Always remove the propane cylinder from the heater when not in use. Always store propane cylinders in a cool, well ventilated place away from any flame or heat and in a location not used for habitation. DO NOT STORE PROPANE TANK WITHIN 60 FT. OF OPEN FLAME OR HEAT. E. See Figure 6 for spare parts list. Figure 5a MODEL MH12TS Mr. Heater | Gas-Fired Infra-Red Portable Heater 6 Operating Instructions and Owner’s Manual Mr. Heater • Gas-Fired Infra-Red Portable Heater • Model #MH12T and #MH12TS NOTE: WHEN LIGHTING BURNER WITH A MATCH OR TAPER, LIGHT AT SCREEN. (NOT AT ORIFICE) Figure 6 Mr. Heater • Gas-Fired Infra-Red Portable Heater • Model #MH12T and #MH12TS NOTE: WHEN LIGHTING BURNER WITH A MATCH OR TAPER, LIGHT AT SCREEN. (NOT AT ORIFICE) Figure 6 REPLACEMENT PARTS LIST FOR HEATER MODELS MH12T AND MH12TS REF.# ITEM# DESCRIPTION 1 F273116 Replacement Safety Shutoff with Orifice Assembly 2 F273117 Thermocouple Lead – 12” Long 3 73122 Plenum Assembly (MH12T only) 4 73107 Plenum Assembly (MH12TS only) 5 F273164 Grid Screen Assembly 6 F273606 Replacement Regulator with Soft Nose POL 7 75102 Wire Faceguard 8 75113 Knurled Lock Nut 9 75128 Reflector (MH12T only) 10 75128S Reflector (MH12TS only) 11 73120 Repl. Reg. H-M-L w/S.S. Tank Union T/C and Orifice 12 75784 Orifice - .018 13 73235 Sparklite Assembly (MH12TS only) 14 73233 Electrode Assembly (MH12TS only) Figure 7 ALL WARRANTY CLAIMS REQUIRE PROOF OF PURCHASE Mr. Heater | Gas-Fired Infra-Red Portable Heater 7 Operating Instructions and Owner’s Manual Model # MH12T MH12TS WARNING: USE ONLY MANUFACTURER’S REPLACEMENT PARTS. USE OF ANY OTHER PARTS COULD CAUSE INJURY OR DEATH. REPLACE...

Questo manuale è adatto anche per i modelli :
Elettrico - MH12TS (693.48 kb)

Scrivi la tua opinione del dispositivo



Il messaggio
Il tuo nome :
Inserire le due cifre :
capcha





categorie