|
Facilità d'uso
Failure to follow instructions may result in property damage, bodily injury, or even death. This furnace meets U.S. Test Standard: UL 391-06 NOTE: Installation MUST be completed by a qualified Heating Equipment Installer! Do NOT use this Furnace in a mobile home, Manufactured Home, Tent or trailer – No Exceptions! Refer to markings on furnace labels for additional information. Vogelzang International Corporation 400 West 17th Street Holland, Michigan 49423 Phone: 1-616-396-1911 Fax: 1-616-396-1971 Page 2 / NORSEMAN™ 1500/2500 Furnace VGZ-018 / 051809.0 SAFETY INSTRUCTIONS Safety Notice: If this furnace is not properly installed, a house/building fire may result. For your safety, contact local building or fire officials about permits, restrictions, and installation requirements for your area. Read All Instructions carefully. Refer to instruction panels, caution and warning plates on furnace for additional information. 1. This furnace is designed to burn coal or wood fuels only and is for INDOOR installation only. DANGER: Risk of fire or explosion. Do not burn garbage, gasoline, drain oil or other flammable liquids. 2. DO NOT attempt to retrofit this unit with any type of water coil or water jacket. 3. The installation of this furnace must comply with your local building code rulings. Please observe the clearances to combustibles (see reference figures 1–3). Do not place furniture or other objects within the clearance area. 4. Verify that the furnace is properly installed before firing for the first time. Obtain the services of a professional licensed installer familiar with all aspects of safe and correct installation. DO NOT use temporary or makeshift compromises during installation. 5. WARNING: Risk of Fire. DO NOT store fuel, flammable liquids or other combustible materials too close to the unit. Refer to the certification label on back of unit and reference clearance instructions in this manual. 6. Do not install this furnace in a mobile home, manufactured home, tent or trailer – NO EXCEPTIONS! (HUD Federal Standard: 24 CFR Ch.XX) 7. If any parts are missing or defective, please notify the manufacturer or dealer immediately. DO NOT OPERATE A STOVE THAT IS MISSING ANY PARTS 8. Always connect this furnace to a chimney and vent to the outside. Never vent to another room or inside a building. DO NOT CONNECT THIS UNIT TO A CHIMNEY FLUE SERVING ANOTHER APPLIANCE. 9. Do NOT connect this furnace to an aluminum Type B gas vent. This is not safe. Use approved masonry or a UL 103 HT Listed Residential Type and Building Heating Appliance Chimney. Use a 6” diameter chimney or larger, that is high enough to provide required draft. (See specifics in installation instructions). WARNING: Risk of Fire. Do not operate with flue draft exceeding 10. Inspect flue pipes, pipe joints, and flue pipe seals regularly to ensure that smoke and flue gases are not drawn into, and circulated by the air circulation system. 11. Cleaning of this furnace, is especially important at the end of the heating season. Accumulated ash attracts moisture and may cause corrosion during the summer months. 12. Be sure that your chimney is safely constructed and in good repair. Have the chimney inspected by the fire department or a qualified inspector. Your insurance company may be able to recommend a qualified inspector. 13. Creosote or soot may build up in the chimney connector and/or chimney and cause a house, building or chimney fire. Inspect the chimney connector and chimney twice monthly during the heating season and clean if necessary. (See Chimney Maintenance, page 18). 14. To prevent injury, do not allow anyone to use this furnace who is unfamiliar with the correct operation of the furnace. 15. Do not operate furnace while under the influence of drugs or alcohol. 16. Ashes should not be allowed to accumulate higher than the ash pan. Dispose of ashes in a metal container with a tight fitting lid. Keep the closed container on a noncombustible floor or on the ground, well away from all combustible materials. Keep the ashes in the closed container until all cinders have thoroughly cooled. The ashes may be buried in the ground or picked up by a refuse collector. 17. Build several small fires on first use. This will help to “season” the cast iron parts and avoid cracking. Allow furnace to cool between firings. 18. The special paints used on your furnace may give off some smoke and an odor while they are curing during the first 12 to 15 fires. Additional smoke and odor may be emitted from the light oils used in construction of the fire box. This should disappear after a short period of time continued on next page and not occur again. Persons with lung conditions or owners of susceptible domestic pets (such as birds) should take prudent precautions. Open windows and doors as needed to clear smoke and/or odor. Paint discoloration will occur if the furnace is over fired. 19. This furnace has a painted surface which is durable but it wi...
Questo manuale è adatto anche per i modelli :Elettrico - 2500 (4.29 mb)