valutazioni - 2, GPA: 5
(
)
)
|
Facilità d'uso
A popup menu will appear with time selections, move the ShuttlePoint knob to the desired selection and press “ENTER”. 3.11.1 Selecting a track line color The chart plotter has 8 different line colors that you can choose for the track plotter. To select from press “MENU”, select TRACK, press “ENTER”, use the ShuttlePoint knob to select LINE COLOR, press “ENTER” and choose the color using the ShuttlePoint knob. 3.11.2 Turning on or off the Track plotter Press “MENU”, select TRACK and press “ENTER”, select TRACKING and press “ENTER”. NOTE It is not possible to use the track function if the chart plotter is not receiving a fix. Page 42 GPS Chart 150C 3.11.3 Saving a track to memory The chart plotter has the capability to store 5 track histories. To store a track press “MENU’, select TRACK and press “ENTER”, select ACTIVE TRACK and press “ENTER”. Select track the next position you want to save the next track to and press “ENTER”. 3.11.4 Displaying track The chart plotter has the capability to enable or disable the displaying of track. Press “MENU’, select TRACK and press “ENTER”, select VISIBLE and press “ENTER”. Select ON to display track on chart (otherwise select OFF) and press “ENTER”. 3.11.5 Deleting track Deletes all tracks. Press “MENU’, select TRACK and press “ENTER”, select DELETE and press “ENTER”. A warning window appears: select YES and press “ENTER”to confirm (select NO otherwise). 3.12 MAINTENANCE The chart plotter does not turn On. The voltage or the polarity may not be correct. Make sure that the correct voltage (10-18 volt dc) is present. Check also that the polarity is correct. Refer to the Section 2.2. The chart plotter does not get a valid fix. The GPS Antenna may not be in a open sky position or the antenna cable may not be properly connected. Make sure that no metal obstacle is placed around the GPS Antenna acting as a shield for the antenna and disconnect and connect again the antenna cable to the chart plotter. If, after 15 minutes, the chart plotter does not get the fix, turn it Off and On again. The chart plotter does not turn Off. The chart plotter may be in an unpredictable status. If, after pressing “PWR” (for at least 3 seconds) the chart plotter does not turn Off, turn Off the voltage. The chart plotter screen becomes very dark after a long exposure to direct sunlight. The internal temperature is very high. Control the contrast. Refer to the Section 2.10. Protect the chart plotter from direct sunlight. The chart plotter does not respond to any command. The chart plotter may be in an unpredictable status. Try to turn Off, and then turn On. If the problem persists, erase the memory *see Section 3.14.0.0) or remove power from the battery. External devices are not receiving data from the chart plotter. The connections or the Software settings may not be right. Check the connections or the settings. GPS Chart 150C Page 43 Page 44 GPS Chart 150C 3.13 SPECIFICATIONS Power consumption : 750mA max @12V Power supply : 10 - 18 Volt dc, 9 Watt max Interface : Input/Output Interface NMEA-0183 Display : TFT Color LCD (active area 5") sunviewable tecnology Display Resolution : 320 x 240 pixels Cartography : C-MAP NT+ C-CARD Operating temperature range : 0/+55 degrees Celsius Storage temperature : -20/+70 degrees Celsius Water Resistence : splash-proof Memory : Non volatile with battery backup Keyboard : Silicon rubber, backlight Weight : 700 gr. (2 pounds) Marks/Waypoints : 600 Waypoints/Routes : respectively 20/30 Track Points : 1000 Figure 3.13 - Chart plotter Dimensions [mm/inch] 3.13.0GPS Receiver Specifications Receiver : L1, C/A code Channels :12 Max Solution Update Rate: 10/sec. Cold Start (avg) : < 45 sec. Warm Start (avg) : < 40 sec. Hot Start (avg) : 8 sec. 3.13.1GPS Antenna Specifications 3.13.1.0Physical Constructions Physical Constructions : Polycarbonate radome, connector for easy mount, rubber-O-ring between top radome and base for waterproof. Dimensions : 60mm in diameter x 38mm in height. Weight : 65grams (w/o cable & connector). Color : Ivory white. Mounting : Flush-mount with double threaded bolt or flag-pole mount with plastic adapter tubing that converts its base into 1'-14 threaded cap. 3.13.1.1Cable & Connector RF cable : 10 meter RG174/U Pulling strength : 6 Kg @ 5sec. molded plastic on connector end for strain relief. Connector : SMA 3.13.1.2Overall Performance (antenna element, LNA & coax cable) Center Frequency : 1575.42 Mhz Gain : 25 dB typical. Noise Figure : 2.0 max. Axial Ratio : 3 dB max. Bandwidth : 2MHz min. VSWR : 2.0 max. Output Impedance : 50 Ohm 3.13.1.3Enviromental Operating Temperature : -40° C~ +85° C. Storage Temperature : -50° C~ +90° C. Relative Humidity : 95% non-condensing. Water Resistance : 100% waterproof. GPS Chart 150C Page 45 3.14 TECHNICAL 3.14.0System Test If you have connected your chart plotter according to the instructions, and chosen the proper menu selection for your device, and are still having problems with your chart plotter, the exten...
Questo manuale è adatto anche per i modelli :Sounders - CP150C (3.24 mb)