|
Facilità d'uso
The rated load is for an evenly distributed, vertically applied load. Overloading may result in personal injury or property damage. • This jack should only be used to help stabilize an already lifted vehicle or support hanging auxiliary components, such as a driveline or transmission. It is not designed to support the weight of an entire vehicle. • ONLY use this jack stand on a hard level surface capable of sustaining the load being supported. • Always make sure that the load point is centered in the saddle and that all three corners of the jack stand base are firmly on the ground. • Never modify or alter this jack stand. • Never release the jack stand when it is supporting a load. • DO NOT over-extend the load. Over extension of the load may cause it to shift and swing. Introduction The Model H8365 V4 ton high jack stand works at heights of 68" to 761/2" and supports a load of up to V4 ton. Figure 1. Model H8365. Assembly Refer to the Parts Breakdown located on the back of this page for assembly. Operation Instructions 1. Before positioning the jack stand under the load, check to make sure that the vehicle is at an appropriate height and is secure. 2. Extend the post by holding the saddle and rotating the handle (Figure 1). Make sure that the saddle is centered under the load point. Do not over-extend the load or the load may shift and swing. 3. Slowly lower the component onto the jack stand, making sure that the load point is still centered and all three corners of the stand base are still on the ground. To remove the jack stand, secure or remove the component until the jack stand can be lowered and removed. Remove the jack stand while the vehicle is securely supported. COPYRIGHT © DECEMBER, 2007 BY GRIZZLY INDUSTRIAL, INC., REVISED FEBRUARY, 2008 (JM) WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC. #JM10211 PRINTED IN CHINA H8365 Parts Breakdown and Parts List REF PART # DESCRIPTION REF PART # DESCRIPTION 1 PH8365001 SADDLE ASSEMBLY 2 P51106 THRUST BEARING 51106 3 PH8365003 GUIDE 4 PH8365004 LEG 5 PH8365005 SMALL BRACE 6 PH8365006 LARGE BRACE 7 PH8365007 ROLL PIN 2 X 25 8 PB09M HEX BOLT M8-1.25 X 20 9 PW01M FLAT WASHER 8MM 10 PN03M HEX NUT M8-1.25 11 PN02M HEX NUT M10-1.5 12 PW04M FLAT WASHER 10MM 13 PB01M HEX BOLT M10-1.5 X 30 14 PH8365014 ID LABEL 15 PH8365015 WARNING LABEL If you need help with the Model H8365, call our Technical Support line at: (570) 546-9663....
Questo manuale è adatto anche per i modelli :Sounders - JACK STAND H8365 (272.61 kb)