|
Facilità d'uso
3. Place the center log (C) as shown. The 2 notches on the bottom of the log should fit over the corresponding locating brackets. 4. Place the top right log (D) as shown. The top fork on log (D) fits into notch on log (A) as shown. The bottom fork on log (D) rests on subfl oor fl ange (identifi ed in photo #1). 5. Place the top left log (B) as shown. The top fork on log (B) fits into notch on log (A). The bottom of the log rests on the subfl oor. WARNING If logs are not installed according to the log installation instructions, flame impingement and improper combustion could occur and result in soot and/or excessive production of carbon monoxide (CO), a colorless, odorless, toxic gas. WARNING DO NOT attempt to install the logs until the appliance installation has been completed, the gas line connected and tested for leaks and the initial burner operation has been checked out. WARNING The size and position of the log set was engineered to give the appliance a safe, reliable and attractive flame pattern. Any attempt to use a different log set in the fireplace will void the warranty and will result in incomplete combustion, sooting, and poor fl ame quality. WARNING This appliance is not designed to burn wood. Any attempt to do so could cause irreparable damage to appliance and prove hazardous to your safety. Bag of Glowing Embers (rockwool) Separate into Quarter Size (separate) Pieces Figure 7 -Glowing Embers REFERENCE Firebox Accessories / Parts Cat. No. Model No. Description 88L53 FGE Bag of Glowing Embers (1 oz. rockwool) 80L42 FDVS Bag of Decorative Volcanic Stone Table 8 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. MODEL SSDV-3530 LOG SET Catalog Number H3367 * Item Description A Log, Rear B Log, Top Left C Log, Center D Log, Top Right * Item "letters" above correspond to photos 9NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. Figure 8 Log Placement Instructions B C D A Install the Embers, Volcanic Stone and Logs in the order shown here (1 through 5) and per the instructions on Page 8. A Notch Notch 2 C 3 Notches on bottom of log (C) fits over 2 locating brackets Top fork on log (B) fits into notch on log (A) B A 4 DA 5 Top fork on log (D) fits into notch on log (A) Place Embers & Volcanic Stone as Shown 1 Volcanic Stone Embers Locating Brackets Notch for top right log (D) Notch for top left log (B) The 2 notches on the bottom of log (A) rest on the locating brackets Sub-Floor Sub-Floor Flange Bottom Fork of log (D) rests on Sub-Floor Flange Bottom of log (B) rests on Sub-Floor MODEL SSDV-4035 A C DB Log Placement Instructions Install the Embers, Volcanic Stone and Logs in the order shown here (1 through 5) and per the instructions on Page 8. D A 4 A Bottom of log (B) rests on subfl oor B Top fork on log (D) fits into notch on log (A) as shown Top fork on log (B) fits into notch on log (A) as shown 1 Place Embers and Volcanic Stone as Shown Volcanic Stone Embers 2 Notch Notch Locating Brackets A 3 C Slots on bottom of Log (C) fits over 2 locating brackets Notch for Top Left log (B) Notch for Top Right log (D) The 2 notches on the bottom of log (A) rest on the locating brackets Sub-Floor Sub-Floor Flange Bottom Fork of log (D) rests on Sub-Floor Flange MODEL SSDV-4035 A C DB Log Placement Instructions Install the Embers, Volcanic Stone and Logs in the order shown here (1 through 5) and per the instructions on Page 8. D A 4 A Bottom of log (B) rests on subfl oor B Top fork on log (D) fits into notch on log (A) as shown Top fork on log (B) fits into notch on log (A) as shown 1 Place Embers and Volcanic Stone as Shown Volcanic Stone Embers 2 Notch Notch Locating Brackets A 3 C Slots on bottom of Log (C) fits over 2 locating brackets Notch for Top Left log (B) Notch for Top Right log (D) The 2 notches on the bottom of log (A) rest on the locating brackets Sub-Floor Sub-Floor Flange Bottom Fork of log (D) rests on Sub-Floor Flange LOG SET Catalog Number H3368 * Item Description A Log, Rear B Log, Top Left C Log, Center D Log, Top Right * Item "letters" above correspond to photos NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. 10 BURNER ADJUSTMENTS (QUALIFIED TECHNICIANS ONLY) Flame Appearance and Sooting Proper flame appearance is a flame which is blue at the base and becomes yellowish-orange in the body of the fl ame. When the appliance is first lit, the entire flame may be blue and will gradually turn yellowish-orange during the first 15 minutes of operation. If after a short period the flame stays lowered blue, or if the flame is orange with evidence of sooting (black tip), the air shutter opening may need to be adjusted. If the air shutter openings closed too far, sooting may develop. Sooting is indicated by black puffs developing at the tips of very long orange flames. Sooting results in black deposits forming on the logs, appliance inside surfaces and on exterior surfaces adjacent to the vent termination. Sooting is caused by incomplete combustion in the flames and lack of combustion air entering the air shutter...
Questo manuale è adatto anche per i modelli :Camini - DIRECT VENT SSDVR-3530CNE (1.77 mb)
Camini - DIRECT VENT SSDVR-3530CNM (1.77 mb)
Camini - DIRECT VENT SSDVR-4035CNE (1.77 mb)
Camini - DIRECT VENT SSDVT-3530CNE (1.77 mb)