valutazioni - 0, GPA: 0
(
)
)
|
Facilità d'uso
Do not use water or dry powder extinguishers. Key to Machine Parts (Page 2) 1 Control panel 2 Cup holder rest 3 Hot water/steam knob 4 Coffee brew unit 5 Water tank 6 Water recovery tray 7 Cup holder grill 8 Steam wand (Pannarello) 9 Power cord socket 10 Water temperature thermometer 11 ON/OFF button 12 "Machine on" light 13 "Coffee brew" but ton 14 "Temperature" light 15 "Rinsing" but ton 16 "Rinsing" light 17 "Steam" button 18 "Steam" light 19 "Descaling" light 20 "Alarm" light 21 Pressurized filter holder 22 Ground coffee measuring scoop 23 Ground coffee filter (single piece for 1 or 2 coffee(s)) 24 Coffee pod filter adapter 25 Coffee pod filter 26 Power cord 27 "Intenza+" water filter (Optional) • 19 • English 4 Installation For your own and other people safet y, carefully follow the "Safety Regulations" indicated in chapter 3. 4.1 Packaging The original packaging has been designed and manufac tured to protect the machine during transpor t. We recommend keeping the packaging material for possible future transpor t. 4.2 Installation Precautions Do not move the machine by grabbing the cup protection grilles. Before installing the machine, read the following safet y precautions carefully: • Place the machine in a safe place. • Make sure children cannot play with the machine. • Do not place the machine on hot surfaces or near open .fl ames The coffee machine is now ready to be connected to the electric 4.4 Machine Connection Elec tric power may be very dangerous! It is therefore necessary to strictly follow the safety regulations. Do not use fault y power cords. Faulty cords and plugs must be replaced immediately by Authorised Ser vice Centres. The voltage of the appliance has been pre-set by the manufac turer. Check that the voltage matches the indication on the data plate at the bot tom of the appliance. • 3A Inser t the plug into the socket on the back of the machine. • 3B Insert the other end of the plug into a wall socket with suitable power voltage. 4.5 First Use At first star t-up, the coffee machine circuit must be primed. 4 Press the ON/OFF but ton (11): the " " light (12) turns on and the " " (14), " " (20) and " " (18) lights blink, prompting the user to prime the circuit. 5 Place a container under the steam wand (Pannarello). network. Note: we recommend washing the components before using them for the first time and/or after they have not been used for a certain period of time. 4.3 Water tank • 1 Remove the water tank (5). • 2 Rinse it and fill it with fresh drinking water, making sure that the (MAX) level indicated in the tank is not exceeded. Fill the tank only with fresh, non-sparkling, drinking water. Hot water or any other liquid may damage the tank. Do not operate the machine when the water level in the tank is below the MIN threshold. Make sure there is enough water in the water tank. • Inser t the water tank back into its seat in the coffee machine and make sure that it locks into place - its profile should adhere to that of the coffee machine. Note: the water level can be checked looking through the window on the front side of the tank. Open the "hot water/steam" knob (3) by turning it clockwise. The pump is activated automatically. Wait until a steady jet of water flows out of the steam wand (Pannarello). 6 Close the "hot water/steam" knob (3) by turning it coun ter-clockwise. Remove the container. The machine begins the warm-up phase only af ter the water circuit has been correctly primed. Note: if the knob is left open, the pump is automatically disengaged af ter a few seconds and the " " light (20) star ts blinking. 4.6 Circuit Priming When the water tank is empty, the machine circuit must be primed again. Note: if the machine has been operating without water for a lot of time and the " " (14), " " (20) and " " (18) lights are blinking, please refer to the "Troubleshooting" table. • 5 Place a container under the steam wand (Pannarello). • Open the "hot water/steam" knob (3) by turning it clockwise. The pump is activated automatically. • Wait until a steady jet of water flows out of the steam wand (Pannarello). • 20 • • 6 Close the "hot water/steam" knob (3) by turning it counter-clockwise. Remove the container. Note: if the steam knob is opened by mistake during the warm-up phase, the " " light (20) star ts blinking. Close the knob and wait until the machine is ready. 4.7 Using the Machine for the First Time orAfter a Period of Inactivity This simple operation ensures an optimum brewing and must be performed: - at first star t-up; - when the machine remains inac tive for a long time (more than 2 weeks). Dispensed water must be emptied into an ad equate drain. It is not suitable for food use. If the container fills up during the c ycle, stop dispensing water and empty the container before resuming the operation. A 2 Rinse the water tank and refi ll it with fresh drinking water. Insert the water tank back into its seat in the coffee machine and make sure that it locks into place - its...