valutazioni - 2, GPA: 4
(
)
)
|
Facilità d'uso
See your Adaptec reseller for purchase information. Installation Checklist . Read and follow the safety tips. See page 2. . Install the enclosure in an equipment rack or tower assembly (optional.) See page 2. . Install the drive carriers. See page 6. . Set the drive slot and enclosure IDs. See page 7. . Connect the I/O cables. See page 7. . Connect the AC power cords to the APC modules. See page 11. . Follow the instructions in Next Steps on page 11. 1 Safety Tips ! Caution: A fully loaded enclosure is heavy. Reduce the weight of the enclosure by removing the drive carriers before installing the enclosure in the rack or tower. (You can also remove the two APCs to further reduce the weight, if required. See the Adaptec Storage Enclosure Installation and User’s Guide on the CD for instructions.) ! ! Caution: To prevent personal injury, have someone assist you during rack installation. Caution: If you are installing your enclosure in a rack, prevent personal injury and equipment damage by following the rack manufacturer’s safety instructions. Install your enclosure only in a rack that has been properly secured in an area with suitable environmental conditions. Step 1: Installing into a Rack or Tower (optional) Note: Mounting rails for rack installation are sold separately. To purchase a rail kit, see your Adaptec reseller. Required tools: ¦ Phillips-head screwdriver ¦ Wrench for tightening nuts (if your rack does not have threaded holes) If you are not installing your Storage Enclosure into a rack or tower, skip to Step 2: Installing the Drive Carriers on page 6. ¦ To install your Storage Enclosure into an rack, see page 3. ¦ To install your Storage Enclosure into a tower assembly, see page 5. 2 Installing into an Equipment Rack Begin the installation by removing the components from the packaging and placing them on an antistatic surface until you need them. Ensure that you have all these rail kit components: ¦ Front rails (1 left, 1 right) ¦ Rear rails, two different sizes (2 left, 2 right) ¦ Two sizes of screws (10 large, 4 small) ¦ Two types of nuts (10 of each) To install your Storage Enclosure in an equipment rack: Secure the front rails to the front supports of the rack, using the supplied screws, as shown below. Note: Use either the speednuts or cagenuts provided if your rack does not have threaded holes. Check the length between the front and rear supports of your equipment rack and determine which set of rear rails to use, the long or the short. 3 3 Secure the rear rails you selected to the rear supports of the equipment rack, using the supplied screws, as shown in the Figure in Step 1 on page 3. 4 Secure the front rails to the rear rails, as shown below. 5 Tighten all the screws before continuing. 6 With assistance from a second person, lift the Storage Enclosure and slide the rear of the enclosure onto the rails. Slide the enclosure all the way back until it rests completely on the rails, as shown in the Figure below. You can choose to ha...
Questo manuale è adatto anche per i modelli :Accessori computer - FS4100 (403.45 kb)
Accessori computer - FS4500 (403.45 kb)
Accessori computer - SC4100 (403.45 kb)