valutazioni - 4, GPA: 4.3 ( )

Produttore : Carrier File Size : 426.56 kb File Nome : 48z-5so.pdf Lingua di insegnamento:

Your combination heating/cooling rooftop unit is equippedwith an automatic direct spark ignition system and induced- draft power combustion blower. WARNING: If the information in this manual is not followed exactly, a fire or explosion may result causing property damage, personal injury or loss of life. — Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. — WHAT TO DO IF YOU SMELL GAS • Do not try to light any appliance. • Do not touch any electrical switch; do not use any phone in your building. • Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions. • If you cannot reach your gas sup- plier, call the fire department. — Installation and service must be per- formed by a qualified installer, service agency or the gas supplier. Improper installation, adjustment, alteration, service, ormaintenance can cause injury or property damage. Refer tothis manual. For assistance or additional information, con- sult a qualified installer, service agency, or the gas supplier. Before performing recommended maintenance, be sure main power switch to unit is turned off. Electrical shockcould cause personal injury. Do not attempt to light by hand; personal injury may result. TO LIGHT UNIT 1. Do not turn off the electrical power to unit withoutfirst turning off the gas supply. 2. Before attempting to start the gas heating section, familiarize yourself with all the procedures that mustbe followed. 3. Never attempt to manually light the unit with a match, lighter, or any other flame. If the electric sparking device fails to light the burners, refer to the shutdownprocedures, then call your dealer as soon as possible. If you do not follow these instructions exactly, a fire orexplosion may result, causing property damage, injury, orloss of life. See Fig. 1 for location of gas valve(s). Refer to Fig. 2 whileproceeding with the following steps. 1. Turn off the unit demand for cooling or heating by usingthe scrolling marquee. The scrolling marquee is located inthe control box at the compressor end of the unit. ESCAPE a. Push the key unit a blank display screen is shown. b. Push the key until the SERVICE TEST LED is lit. c. Push the ENTER key. The display will show STOP. d. Push the ENTER key again. The NO/YES display will flash. e. Push the or key to toggle the display to YES and then push ENTER . The unit will be locked off from heating, cooling or any operation. The controls will still function and the display willstill operate. 2. Close the field-installed manual gas shutoff valve. 3. Turn off the electrical power to the unit using the optionaldisconnect or the field-installed disconnect and lock off using proper lockout and tag-out procedures. 4. Open the burner section hinged access door. 5. Move the switch on the gas valves to the OFF position and wait 5 minutes. NOTE: If this is the first installation of the unit, the gas flue hoods must be installed before operating unit. These must be installed for the unit to run properly. 6. Move the switch on the gas valves to the ON position. 7. Close the burner section hinged access door. 8. Turn on the electrical supply to the units. 9. Open the field-installed manual gas valve. Manufacturer reserves the right to discontinue, or change at any time, specifications or designs without notice and without incurring obligations. Catalog No. 04-53480045-01 Printed in U.S.A. Form 48Z-5SO Pg 1 7-07 Replaces: 48Z-3SO Book Tab 1a NOTE: High heat co...

Scarica la tua

Per scaricare, digitare 2 cifre :