The horizontal air direction is adjusted by rotating the vertical louver right or left by Remote Controller. The direction of air can be controlled wherever you want to cool by adjusting the horizontal louver and the vertical louver. • VERTICAL AIR-DIRECTION CONTROL • HORIZONTAL AIR-DIRECTION CONTROL How to Secure the Drain Pipe In humid weather, excess water may cause the BASE PAN to overflow. To drain the water, remove the DRAIN CAP and secure the DRAIN PIPE to the rear hole of the BASE PAN. Press the drain pipe into the hole by pushing down and away from the fins to avoid injury. (See Fig.1) Optional(CW3H02502C) 1. Remove the rubber plug and slide the chassis out from the cabinet. (See Fig.2) 2. Install the drain pan over the corner of the cabinet where you removed the plug with 4 screws. (See Fig.3) 3. Connect the drain hose to the outlet located at the bottom of the drain pan. You can purchase the drain hose or tubing locally to satisfy your particular needs. (Drain hose is not supplied). (See Fig.3) 4. Select the most appropriate connection from among the figures to the right (by considering the hole of the unit) to fit drain pan to your own unit. (See Fig.3) 5. Slide the chassis back into the cabinet. Reinstall the cabinet screws. Secure the cabinet to chassis by using screws. (See Fig.4) 6 About the Controls on the Air Conditioner CLOSE VENT OPEN Part A Part B Drain pipe Drain cap Fig. 4 Fig. 3 Fig. 2 DRAIN HOSE Inside diameter 17mm (5/8") Fig. 1 OFF/ON OPERATION TEMP/TIMER COOL FAN HIGH MED LOW MODE FAN SPEED SET TIMER SET/ CANCEL AIR SWING ECONOMY hr F Wireless Remote Control DRAIN PAN CABINET SCREW Remove the rubber plug OFF/ON OPERATION TEP/TI COOL FAN HIGH MED LOW MOE FAN SPEED SET TIMER SET/ CNE AIR ECONOMY F Wireless Remote Control NOTE: Before using the ventilation feature, and prior to installing the front grille, pull down part until level with part . 7 About the Controls on the Air Conditioner Air Filter Cleaning The air filter behind the front grille should be checked and cleaned at least once every 2 weeks or more often if necessary. The grille is designed to clean the filter both upward and downward. TO REMOVE: 1. Open the inlet grille upward by pulling out the bottom of the inlet grille or downward by pulling out the top of the inlet grille. 2. Using the tab, pull up slightly on the filter to release it and pull it down or up. 3. Clean the filter with warm, soapy water under 40°C (104°F). 4. Rinse and gently shake the water from the filter and let it dry before replacing it. CAUTION: DO NOT operate the air conditioner without a filter because dirt and lint will clog it and reduce performance. Care and Maintenance TURN THE AIR CONDITIONER OFF AND REMOVE THE PLUG FROM THE POWER OUTLET. 8 Features and Installation Learning parts name prior to installation will help you understand the installation procedure. Features Features CABINET FRONT GRILLE AIR FILTER AIR INTAKE (INLET GRILLE) AIR DISCHARGE HORIZONTAL AIR DEFLECTOR (VERTICAL LOUVER) VERTICAL AIR DEFLECTOR (HORIZONTAL LOUVER) EVAPORATOR CONTROL BOARD POWER CORD BASE PAN CONDENSER COMPRESSOR BRACE REMOTE CONTROLLER Installation About 1/2" Over 20" HEAT RADIATION FENCE AWNING INSIDE OUTSIDE FOAM COOLED AIR 30-60" Level 1/4 Bubble How to Install the Unit 1. To avoid vibration and noise, make sure the unit is installed securely and firmly. 2. Install the unit where the sunlight does not shine directly on the unit. If the unit receives direct sunlight, build an awning to shade the cabinet. 3. There should be no obstacle, like a fence, within 20” which might restrict heat radiation from the condenser. 4. To prevent reducing performance, install the unit so that louvers of the cabinet are not blocked. 5. Install the unit a little obliquely outward not to avoid leaking the condensed water into the room (about 1/2” or 1/4 bubble with level). 6. Install the unit with its bottom portion 30~60” above the floor level. 7. Stuff the foam between the top of the unit and the wall to prevent air and insects from getting into the room. 8. The power cord must be connected to an independent circuit. The green wire must be grounded. 9. Connect the drain tube to the base pan hole in the rear side if you need to drain (consult a dealer.) Plastic hose or equivalent may be connected to the drain tube. Window Requirements NOTE: All suppo...

Questo manuale è adatto anche per i modelli :
Condizionatori - HQ-2244UH (3.26 mb)
Condizionatori - HQ-2244UH (3.26 mb)
Condizionatori - HQ-2244UH (3.26 mb)
Condizionatori - HQ-2244UH (3.26 mb)