valutazioni - 2, GPA: 4
(
)
)
|
Facilità d'uso
>• Condensation effect due to cooling process. Water flowing sound during operation. >• Refrigerant flow inside the unit. The room has a peculiar odor. >• This may be due to damp smell emitted by the wall, carpet, furniture or clothing. Indoor fan stops occasionally during automatic fan speed >• This helps to remove the surrounding odours. setting. Airflow continues even after operation has stopped. >• Extraction of remaining heat from the indoor unit(maximum 30 seconds). Operation is delayed a few minutes after restarting. >• The delay is a protection to the unit’s compressor. Outdoor unit emits water/steam. >• Condensation or evaporation occurs on pipes. TIMER indicator is always on. >• The timer setting repeats daily once set. POWER indicator blinks during operation and the indoor >• The unit is in defrost mode, and the melted frost is fan is stopped. drained from the outdoor unit. Indoor fan stops occasionally during heating operation. >• To avoid unintended cooling effect. POWER indicator blinks before the unit is switched on. >• This is preliminary step in preparation for the operationwhen the ON timer has been set. Cracking sound during operation. >• Changes of temperature caused the expansion/ contraction of the unit. SYMPTOMSYMPTOM CHECKCHECK Heating/Cooling operation is not working efficiently. > • Set the temperature correctly. • Close all doors and windows. • Clean or replace the filters. • Clear any obstruction at the air inlet and air outlet vents. Noisy during operation. > • Check if the unit has been installed at an incline. • Close the front panel properly. Remote control does not work. > • Insert the batteries correctly. (Display is dim or transmission signal is weak.) • Replace weak batteries. The unit does not work. > • Check if the circuit breaker is tripped. • Check if timers have been set. The unit does not receive the signal from the remote > • Make sure the receiver is not obstructed. control. • Certain fluorescent lights may interfere with signaltransmitter. Please consult authorized dealer. INFORMATION FOR SEASONAL INSPECTION AFTER EXTENDED NON SERVICEABLE CRITERIAS NON-USE TURN OFF POWER SUPPLY AND UNPLUG then • Checking of remote control batteries. please consult authorized dealer under the following • No obstruction at air inlet and air outlet vents. conditions: • After 15 minutes of operation, it is normal to have the • Abnormal noise during operation. following temperature difference between air inlet and air • Water/foreign particles have entered the remote outlet vents: control. Cooling: . 8°C Heating: . 14°C • Water leaks from Indoor unit. • Circuit breaker switches off frequently. FOR EXTENDED NON-USE • Power cord becomes unnaturally warm. • Switches or buttons are not functioning properly. • Activate Heat mode for 2~3 hours as an alternative to remove moisture left in the internal parts thoroughly toprevent mould growth. • Turn off the power supply and unplug. • Remove the remote control batteries. Information for Users on Collection and Disposal of Old Equipment and used Batteries [Information on Disposal in other Countries Note for the battery symbol (bottom two outside the European Union] symbol examples): These symbols are only valid in the European This symbol might be used in combination with Union. If you wish to discard these items, a chemical symbol. In this case it complies with please contact your local authorities or dealer the requirement set by the Directive for the and ask for the correct method of disposal. chemical involved. Pb ENGLISH Declaration of Conformity Declaration of Conformity with the requirements of Technical Regulation on the Restriction Of the use of certain Hazardous Substances in Electrical and Electronic Equipment (adopted by Order №1057 of Cabinet of Ministers of Ukraine) The Product is in conformity with the requirements of Technical Regulation on the Restriction Of the use of certain Hazardous Substances in electrical and electronic equipment (TR on RoHS). The content of hazardous substance with the exemption of the applications listed in the Annex №2 of TR on RoHS: 1. Lead (Pb) – not over 0,1wt % or 1000wt ppm; 2. Cadmium (Cd) – not over 0,01wt % or 100wt ppm; 3. Mercury (Hg) – not over 0,1wt % or 1000wt ppm; 4. Hexavalent chromium (Cr6+) – not over 0,1wt % or 1000wt ppm; 5. Polybrominated biphenyls (PBBs) – not over 0,1wt % or 1000wt ppm; 6. Polybrominated diphenyl ethers (PBDEs) – not over 0,1wt % or 1000wt ppm. ME67 © ПанасоникЭплаинсесАирнарушениемзакона. упаковкеинаизделии. ME67 © ПанасоникЭплаинсесАирнарушениемзакона. упаковкеинаизделии. Инструкции по эксплуатации Кондиционер Модель №. Внутренний блок Внешний блок CS-W18NKD CU-W18NKD CS-W24NKD CU-W24NKD Название и адрес завода-изготовителя указаны на -Кондишенинг Малайзия Сдн., Бхд. 2012. Неразрешенное копирование и распространение являются ПРЕДУПРЕЖДЕНИЕПРЕДУПРЕЖДЕНИЕЭтотсимволпредупреждаетосмертельнойопасностиилиорискеполучениясерьезнойтравмы. ПРЕДОСТЕРЕЖЕНИЕПРЕДОСТЕРЕЖЕНИЕЭт...
Questo manuale è adatto anche per i modelli :Condizionatori - CS-W18 (2.23 mb)