valutazioni - 4, GPA: 4.5
(
)
)
|
Facilità d'uso
Securely clamp the boards to the KATIE JIG® System using 2 clamps. Placement of these clamps should be done to best accommodate the boards. CAUTION: Make sure the clamps do not interfere with the router bits. Prepare Router Table and Set Height of Bits For best results, use two routers mounted in router table. Determine height for dovetail bit. At least 1/16" of bearing must extend above base of router table. Dovetail bit depth Thickness of pin board Trim stock or spacer 1/2" for guide/tuning forks Base of router table Copyright © 1997-2000 Hampton House, Inc. Page C-1 Determine height for pattern bit. Routing Pins and Tails Grasp the router table handles on the side opposite the board that you wish to route, and slide the KATIE JIG™ System toward the bit. Carefully route the areas between each of the guide/tuning forks. CAUTION: DO NOT lift the KATIE JIG™ System while the router is running! Slide fixture toward bit Page C-2 Copyright © 1997-2000 Hampton House, Inc....