Spring Return Fuel Tank Capacity................................................................................................................................. 14 ounces (415 ml) CULTIVATOR* Drive Shaft Tube .................................................................................................................................................. Steel Tube Throttle Control ...................................................................................................................

10. Keep the throttle squeezed and allow the engine to warm up for 15 to 30 seconds. 11. Place the choke lever in Position 3. Release the throttle control to the idle position and begin operation. IF... The engine does not start, repeat Steps 4 - 11. IF... The engine fails to start after a few attempts, place the choke lever in Position 3 and squeeze the throttle control. Pull the starter rope 3 to 8 times. The engine should start. If not, continue pulling starter rope until the engine starts. I

Drain all fuel from the fuel tank into a container. Do not use fuel that has been stored for more than 60 days. Dispose of the old fuel in accordance to local regulations. 2. Start the engine and allow it to run until it stalls. This ensures that all fuel has been drained from the carburetor. 3. Allow the engine to cool. Remove the spark plug and put 1 oz. (30 ml) of high quality motor oil into the cylinder. Pull the starter rope slowly to distribute the oil. Reinstall the spark plug. NOTE: Remo

SPECIFICATIONS ENGINE* Engine Type........................................................................................................................................... Air-Cooled, 2-Cycle Displacement .............................................................................................................................................................. 31 cc Idle Speed RPM .................................................................................................................

Lay all the loose parts in carton out on floor or work bench. , Separate all of the hardware (nuts and bolts) into groups. Preassemble eleven clamps {Ref. 10) and hex bolts 1/2" x 1.50" long (Ref. 4). Thread bolts into clamps until one thread shows through weld nut. Preassemble two wheels (Ref. 11), wheel rods (Ref. 14), shoulder bolts (Ref. 12) and hex lock \ nuts (Ref, 13). Place shoulder bolt through wheel and thread into wheel rod. Secure shoulder bolt with hex lock nut. Model No. 193-98