valutazioni - 3, GPA: 4.7
(
)
)
|
Facilità d'uso
When cutting operation requires the resting of the saw on the workpiece, the saw shall be rested on the larger portion and the smaller piece cut off. I To avoid kickback do support board Don't support board or panel away or panel near the cut. from the cut. I Fig. Fig. 2 5 Do not use dull or damaged blade. Unsharpened or improperly set blades produce narrow kerf causing excessive friction, blade binding and KICKBACK. Blade depth and bevel adjusting locking levers must be tight and secure before making cut. If blade adjustment shifts while cutting, it may cause bind- ing and KICKBACK. Use extra caution when making a "Pocket Cut" into existing walls or other blind areas. The protruding blade may cut objects that can cause KICKBACK. NEVER place your hand or fingers behind the saw. If kickback occurs, the saw could easily jump backwards over your hand, possibly causing severe injury. 1 Fig. 3 12. Adjustments. Before cutting be sure depth and bevel adjustments are tight. 13.Avoid Cutting Nails. Inspect for and remove all nails from lumber before cutting. 14. Place the wider portion of the saw base on that part of the workpiece which is solidly supported, not on the section that will fall off when the cut is made. As examples, Fig. 4 illustrates the RIGHT way to cut off the end of a board, and Fig. 5 the WRONG way. If the workpiece is short or small, clamp itdown. DON'T TRY TO HOLD SHORT PLACES BY HAND! Fig. Fig. 5 15. Never attempt to saw with the circular saw held upside down in a vise. This is extremely dangerous and can lead to serious accidents. Fig. t 16. Before setting the tool down after completing a cut, be sure that the lower (telescoping) guard has closed and the blade has come to a complete stop. SYMBOLS The followings show the symbols used for tool. v ................................. volts -................................. direct current n, ................................. no load speed .../min ................................ revolutions or reciprocation per minute IMPORTANT SAFETY INSTRUCTIONS FOR CHARGER & BATTERY CARTRIDGE 1. SAVE THESE INSTRUCTIONS - This manual contains important safety and operating instructions for battery charger. 2. Before using battery charger, read all instructions and cautionary markings on (1)battery charger, (2) battery, and (3)product using battery. 3. CAUTION -To reduce risk of injury, charge only MAKITA Battery Cartridge 7000, 7001, 7002, 7033, 7100, 7120, 9000, 9001, 9002, 9033, 9100, 9101,9102,9120,9122,9133,1200,1201,1202,1210,1211,1220,1222, 1233, 1422, 1433, 9101A. 9102A, 1201A. 1202A. 1822 or 1833. Other types of batteries may burst causing personal injury and damage. 4. Do not expose charger to rain or snow. 5. Use of an attachment not recommended or sold by the battery charger manufacturer may result ina risk of fire, electric shock, or injury to persons. 6. To reduce risk of damage to electric plug and cord, pull by plug rather than cord when disconnecting charger. 7. Make sure cord is located...
Questo manuale è adatto anche per i modelli :Jig Saw e - 5026DA (1.1 mb)
Jig Saw e - 5046DWA (1.1 mb)
Jig Saw e - 5026DWA (1.1 mb)
Jig Saw e - 5026DWB (1.1 mb)