valutazioni - 3, GPA: 3.7
(
)
)
|
Facilità d'uso
Push down on the rip fence handle to lock the rip • fence in place. TO INSTALL INDICATOR ON LEFT SIDE REARRAIL HOOKOVER REARRAIL HERE Fig. 12 RIP FENCEHANDLE Fig. 13 CHECKING RIP FENCE AND. BLADE ALIGNMENT The rip fence is self-aligning but should be checked before first use. _. WARNING: Failure to align the rip fence to the blade can cause jams and kickback, resulting in serious personal injury. • Slide the rip fence to the miter gauge groove, which is parallel to blade. Do not lock the rip fence. • Place a framing square against the blade, with the long end under the rip fence at the front. See Figure 14. Note the distance. • Move the square to the back and measure the length from other end of the fence. See Figure 15. • If the distances are different, loosen the four screws around the rip fence handle with a 6 mm hex key. Alternate the order (remove the screw opposite, not next to the first one). See Figure 16. • Hold the fence handle against the front rail and align the rip fence with the blade. • Retighten the screws in alternating order and check the alignment. • Repeat until the rip fence is aligned. MITERGAUGEGROOVE BLADE RIPFENCE MITERGAUGEGROOVE FRAMING SQUARE ADJUSTMENTSCREWS RIPFENCE Fig. 15 ADJUSTMENT SCREWS(4) RIPFENCE HANDLE Fig. 16 MITERGAUGE GROOVE Note: To insure proper self alignment when positioning rip fence, push sides of scale indicator housing against front rail before locking rip fence handle. Fig. 14 8 ...
Questo manuale è adatto anche per i modelli :Jig Saw e - 113.29931 (220.94 kb)
Jig Saw e - 113.29941 (220.94 kb)
Jig Saw e - 113.29951 (220.94 kb)
Jig Saw e - 315.22831 (220.94 kb)