valutazioni - 3, GPA: 3.7
(
)
)
|
Facilità d'uso
If so, move the mobile phone away from this unit when it is in use. • Moving the unit Turn off the power and unplug the power cord from the power outlet. Next, disconnect the connection cables to other system units before moving the unit. • Note that the illustrations in these instructions may differ from the actual unit for explanation purposes. Cautions on Installation Note: For proper heat dispersal, do not install this unit in a confined space, such as a bookcase or similar enclosure. b Note b Wall b b About the Remote Control Unit In addition to the AVR-3808CI, the included main remote control unit (RC-1068) can also be used to operate the equipment listed below. q DENON system components w Non-DENON system components • By setting the preset memory (vpage 59 ~ 61) • By using the learn function (vpage 62) Inserting the Batteries q Lift the clasp and remove the rear lid. (RC-1068) (RC-1070) w Load the two batteries properly as indicated by the marks in the battery compartment. (RC-1068) (RC-1070) LR6/AA R03/AAA e Put the rear cover back on. NOTE • Replace the batteries with new ones if the set does not operate even when the remote control unit is operated close to the unit. • The supplied batteries are only for verifying operation. • When inserting the batteries, be sure to do so in the proper direction, following the “q” and “w” marks in the battery compartment. • To prevent damage or leakage of battery fluid: • Do not use a new battery together with an old one. • Do not use two different types of batteries. • Do not attempt to charge dry batteries. • Do not short-circuit, disassemble, heat or dispose of batteries in flames. • If the battery fluid should leak, carefully wipe the fluid off the inside of the battery compartment and insert new batteries. • Remove the batteries from the remote control unit if it will not be in use for long periods. • When replacing the batteries, have the new batteries ready and insert them as quickly as possible. Operating Range of the Remote Control Unit Point the remote control unit at the remote sensor when operating it. 30° 30° Approx. 23 feet / 7 m or (RC-1068) (RC-1070) NOTE The set may function improperly or the remote control unit may not operate if the remote control sensor is exposed to direct sunlight, strong artificial light from an inverter type fluorescent lamp or infrared light. Part Names and Functions W6 USB port······················································ (18) E0 DIRECT/STEREO button····························· (41) W7 STATUS button ··········································· (45) E1 PURE DIRECT button·································· (41) For buttons not explained here, see the page indicated in parentheses ( ). W8 AUDIO DELAY button ································· (44) E2 DSP SIMULATION button ·························· (41) W9 RESTORER button ······································ (43) E3 STANDARD button ····································· (40) Front Panel Display Getting Started Connections Setup Playback Remote Control Multi-Information Troubleshooting oiuy t Q. Q0i weqrQ3Q2Q1Q0 yQ6Q7uoQ1Q2Q3Q5 GWith the door openG E. E2E1E0W9W. W. W. W5W4W. Q4Q5Q6Q7Q8Q9W0W1W2 q Power operation button (ON/STANDBY) ··········································· (46) w Power indicator··········································· (46) e Power switch (hON jOFF) ····················· (46) r QUICK SELECT buttons / indicators········· (57) t MASTER VOLUME control knob················ (46) y Master volume indicator u Display i Remote control sensor································· (3) o SOURCE SELECT knob······························· (36) Q0 SOURCE button ·········································· (36) Q1 TUNING PRESET button ···························· (48) Q2 ZONE2/3 / REC SELECT button ·········· (56, 71) Q3 VIDEO SELECT button ······························· (38) Q4 Headphones jack (PHONES)······················ (46) Q5 ZONE2 ON/OFF button ······························ (71) Q6 ZONE3 ON/OFF button ······························ (71) Q7 INPUT MODE button ·································· (38) Q8 MENU button·············································· (23) Q9 Cursor buttons (uio p) ·························· (23) W0 CH SEL / ENTER button ······················· (23, 56) W1 RETURN button ·········································· (23) W2 V.AUX INPUT connectors··························· (17) W3 SETUP MIC jack ·········································· (25) W4 ROOM EQ button········································ (43) W5 DIMMER button ·········································· (35) qw q Input signal indicators w Input signal channel indicators These light when digital signals are input. e Information display The input source name, surround mode, setting values and other information are displayed here. r Output signal channel indicators t Surround speaker indicators These light according to the settings of the surround A and B speakers. y Master volume indic...