Produttore : Furuno
File Size : 1.08 mb
File Nome : e3e6de6c-b2b9-495e-b19a-941dc2f1d793.pdf
|
Facilità d'uso
FURUNO Authorized Distributor/Dealer 9-52 Ashihara-cho, Nishinomiya 662-8580, JAPAN Telephone : 0798-65-2111 Fax : 0798-65-4200 All rights reserved. Printed in Japan FIRST EDITION : APR. 2003 G1 :OCT. 17, 2005 Pub. No. OME-72500 *00014698405* ( HIMA ) NAVPILOT-500 *00014698405* * 0 0 0 1 4 6 9 8 4 0 5 * *OME72500G10* *OME72500G10* * O M E 7 2 5 0 0 G 1 0 * SAFETY INSTRUCTIONS SAFETY INSTRUCTIONS WARNING Do not open the equipment unless you are well familiar with electrical circuits. Only qualified personnel should work inside the equipment. ELECTRICAL SHOCK HAZARD Do not set the course changing speed too high. The boat will be turned too sharply at the course change, which could create a very dangerous situation. Do not use the autopilot in the following situation: Harbor entrance or narrow channel Where vessels change course often, such as a cape or small island Observe the following cautions when using the autopilot: Maintain a vigilant watch Watch for drifting of vessel In an emergency, manually steer the vessel. The autopilot cannot avoid vessels, etc. automatically. Set the turn rate properly. Setting the too high rate may cause sudden turn. When connecting a geomagnetism detection type heading sensor, correct magnetic field deviation. If an autopilot is used without the compensation, unexpected course change may occur. WARNING Do not use the ORBIT mode in rough sea. Because the boat turns a 360-degree circle around the waypoint a large wave or strong wind can cause the boat to capsize. For the figure eight mode, confirm that no objection is in the general vicinity of the waypoint. The distance from the waypoint to the turning point depends on boat's speed. Do not use the SIMULATION mode on the boat. The rudder may move. This is special- purpose mode for technicians. CAUTION In case of power failure turn off the autopilot or manually steer the vessel. Leaving the equipment in the AUTO or NAV mode during power failure will cause wear on the rudder mechanism. WARNING To avoid electrical shock, do not remove cover. No user-serviceable parts inside. Use the correct fuse. Use of a wrong fuse can cause fire or damage the equipment. WARNING LABEL A warning label is attached to the processor unit. Do not remove the label. If the label is missing or damaged, contact your dealer about replacement. Name: Warning Label (1) Type: 86-003-1011 Code No.: 100-236-231 i TABLE OF CONTENTS FOREWORD ........................................................................................................ iv SYSTEM CONFIGURATION................................................................................. v 1. PRINCIPLE OF THE AUTOPILOT................................................................1-1 1.1 Principle of Autopilot ....................................................................................................1-1 1.2 Principle of Operation ..................................................................................................1-2 2. BASIC OPERATION......................................................................................2-1 2.1 Operating Controls.......................................................................................................2-1 2.2 Turning On/Off..............................................................................................................2-2 2.3 Adjusting Brilliance and Contrast .................................................................................2-3 2.4 Displays .......................................................................................................................2-3 2.4.1 Choosing the display mode.................................................................................2-3 2.4.2 Selecting the data shown on Normal Display 2, Data Display and Graphic Display ......................................................................2-4 3. STEERING MODES ......................................................................................3-1 3.1 STBY Mode..................................................................................................................3-1 3.2 AUTO Mode .................................................................................................................3-2 3.2.1 Using the AUTO mode ........................................................................................3-2 3.2.2 ADVANCED AUTO mode....................................................................................3-3 3.3 NAV Mode....................................................................................................................3-4 3.3.1 Starting the NAV mode........................................................................................3-4 3.3.2 Selecting sailing method of NAV mode ...............................................................3-5 3.3.3 Switching waypoint..............................................................................................3-6 3.3.4 Selecting th...