valutazioni - 2, GPA: 4.5
(
)
)
|
Facilità d'uso
NOTES: • Please avoid using this unit in places of high temperature or humidity over prolonged periods of time as damage may occur. • Exposure to direct sunlight in places such as car interiors may cause the unit to become warped and/or lead to malfunctioning. • Avoid using or storing this unit in dusty or sandy locations. For future reference, record the serial number in the space provided. Model No: DTE200 Serial Number____________________ 1 POWER SOURCES (CONTINUED) Remove the battery cover on the rear of the unit and insert four (4) “C” cell batteries (not included), observing the battery polarity indicated in the compartment. Replace the Battery Compartment cover. LOCATION OF CONTROLS + + - - (Pencil comment ksl 17.07.2006 10:29:21 blank) OPERATION HEADPHONES JACK For private listening, connect low impedance 3.5mm (32 ohm) headphones (not included) to this jack. TO LISTEN TO THE FM RADIO Slide the Function switch to the RADIO position. a station by turning the TUNING control 1. Adjust the VOLUME control 2 as desired. 1 1122 Antennas FM: Turn the unit for best FM reception. 3 1. Cassette Compartment 2. FAST FORWARD l Button 3. PLAY ® Button 4. STOP n Button 5. VOLUME Control 6. FM Antenna 7. Earphone Jack 8. Function (TAPE/RADIO) Switch 9. TUNING Control 10. Battery Compartment (Rear of Unit) 11. DC 6V Jack (Rear of Unit) (Pencil comment ksl 17.07.2006 10:29:38 blank) POWER SOURCES AC OPERATION To operate the unit using AC power, connect a 6V, 300mA z AC adapter (not included) to an AC outlet having 120V, 60Hz AC only. Plug the small end into the DC 6V jack on the rear of the unit and connect the other end into the AC outlet. The batteries are automatically disconnected when the AC adapter is used. CAUTION: When not using AC power, disconnect the AC adapter from the wall outlet by pulling the plug (not the cord). Do not touch the AC adapter with wet hands. Fully insert the plug without exposing any part of the blade. NOTE: AC adapter sold separately. BATTERY PRECAUTIONS Follow these precautions when using batteries in this device: 1. Use only the size and type of batteries specified. 2. Be sure to follow the correct polarity when installing the batteries as indicated in the battery compartment. Reversed batteries may cause damage to the device. 3. Do not mix different types of batteries together (e.g. Alkaline and Carbon-zinc) or old batteries with fresh ones. 4. If the device is not to be used for a long period of time, remove the batteries to prevent damage or injury from possible battery leakage. 5. Do not try to recharge batteries not intended to be recharged; they can overheat and rupture. (Follow battery manufacturer’s directions.) 2 OPERATION(CONTINUED)CARE ANDMAINTENANCEOPERATION(CONTINUED)CARE ANDMAINTENANCE TO PLAY A TAPE 1 Liftupthecassettedoorandinsertaprerecordedtape.Closethecassettedoor.SettheFunctionswitchtotheTAPEposition. PushthePLAYbutton tostartplaybackandadjusttheVOLUMEcontrol asdesired. Tostopthetapebeforeitreachestheend,pushtheSTOPbutton. 3AUTOMATICSTOPThiscassetteplayerhasabuilt-inAutomaticStopSystemthatstopsthetapewhenitreachestheendinthePlaymode. TO FAST FORWARD A TAPE 4TOFASTFORWARDATAPETorapidlyadvancethetape,pushtheFastForwardbutton.Torapidlyadvancethetapewhileintheplaymode,pushtheSTOPbutton beforepressingtheFastForwardbutton .1121 TROUBLESHOOTINGGUIDE Should this unit develop a problem, check the following before seeking service. SYMPTOMPOSSIBLEPOSSIBLECAUSESOLUTION GENERAL Power does Batteries are weak, Insert batteries not come on. dead or not inserted properly or replace with correctly. fresh batteries. RADIO No sound. Function switch not Set Function switch set to RADIO position. to RADIO position. VOLUME control at Turn the VOLUME minimum position. control up. Noise or sound FM–Interference. Turn the unit for distorted. best reception. CASSETTE No sound. Function switch not Set Function switch to set to TAPE position. TAPE position. VOLUME control at Turn the VOLUME minimum position. control up. Sound distorted. Dirty head. Clean head. 122 CASSETTE TAPE USAGE Longer length tapes of 45 (C-90) and 60 (C-120) minutes of playing time on each side are not recommended. These tapes use thinner material and have a greater chance for malfunction such as tape spillage from the cassette, internal binding and tape tearing. Use only high quality tapes. If there is any slack in the tape, remove it before inserting the cassette. To do so, place a pencil in one of the hubs and rotate it until the slack is taken up. CARE AND MAINTENANCE Clean the tape head, capstan and pinch roller using a cotton swab slightly moistened with alcohol. Avoid scratching the head surface. To clean the unit housing, use a soft cloth slightly dampened with water and wipe dry. Cotton Swab Capstan Head Pinch Roller CAUTION: Never use chemicals such as benzene or paint thinner for cleaning, otherwise the case may become deformed or discolored. 5 LIMITED WARRANTY Emerson Radio Corp. warrants manufacturing defects...