valutazioni - 2, GPA: 3.5 ( )

Produttore : Homelite File Size : 1.08 mb File Nome : Lingua di insegnamento:

4 Page 10 Page 11 .... .. ..WING NUT MOUNTING BRACKET GEAR HEAD DRIVE SHAFT LOCATOR HOLE LOCATOR PIN SCREW SLOT GRASS DEFLECTOR ...... .... .............. .. ...... .... ...... .. ASSEMBLED EDGER GUIDE TABS CURVED SHAFT GRASS DEFLECTOR WITH EDGER GUIDE - TRIM ‘N EDGE ONLY See Figures 5 and 6. 1. Remove the wing nut, flat washer, lock washer, and bolt from the Owner’s Kit. 2. Place the curved shaft grass deflector over the shaft and bracket. 3. Slide the assembled edger guide over the tabs on the grass deflector and bracket. 4. Place the bolt through the slots in the tabs on the grass deflector and trimmer. NOTE: Ensure the slots are aligned before installing the bolt. 5. Install the flat washer, lock washer and wing nut. 6. Tighten the wing nut securely. STRAIGHT SHAFT GRASS DEFLECTOR - EASY REACH See Figure 7. 1. Remove the wing nut and clamp from the grass deflector. 2. Assemble straight shaft grass deflector to drive shaft so that the peg in the grass deflector fits in the locator hole in the lower side of the drive shaft near the gear head. 3. Place the mounting bracket over the drive shaft so the square tab on the mounting bracket fits into the slot in the straight shaft grass deflector. 4. Rotate the mounting bracket so the screw on the grass deflector goes into the slot on the mounting bracket. 5. Install the wing nut and tighten securely. FLAT WASHER LOCK WASHER WING NUT LONG BOLT Fig. 6 Fig. 7 Fig. 5 ASSEMBLY Page 12 FUELING AND REFUELING THE TRIMMER FUEL MIXTURE This product is powered by a 2-cycle engine and requires pre-mixing gasoline and 2-cycle oil. Pre-mix unleaded gasoline and 2-cycle engine oil in a clean 1 gallon container approved for gasoline. Recommended fuel: This engine is certified to operate on unleaded gasoline intended for automotive use. Mix Homelite Premium Exact Mix oil with gasoline according to the instructions on the package. If Premium Exact Mix oil is not available, use a high quality 2-cycle engine oil, mixed at 2.6 oz. per gallon (US). Do not use automotive oil or 2-cycle outboard oil. NOTE: Premium Exact Mix fuel mix will stay fresh up to 30 days. DO NOT mix quantities larger than usable in a 30 day period. FUEL MIXTURE OPERATING THE TRIMMER See Figure 8. WARNING: Always position the unit on the operator's right side. The use of the unit on the operator's left side will expose the user to hot surfaces and can result in possible burn injury. WARNING: To avoid burns from hot surfaces, never operate unit with the bottom of the engine above waist level. Hold the trimmer with the right hand on the rear handle and the left hand on the front handle. Keep a firm grip with both hands while in operation. Trimmer should be held at a comfortable position with the rear handle about hip height. Always operate trimmer at full throttle. Cut tall grass from the top down. This will prevent grass from wrapping around the shaft housing and string head which may cause damage from overheating. If grass becomes wrapped around the string head, STOP THE ENGINE, disconnect the spark plug wire, and remove the grass. Prolonged cutting at partial throttle will result in oil dripping from the muffler. FILLING TANK 1. Clean surface around fuel cap to prevent contamination. 2. Loosen fuel cap slowly. Rest the cap on a clean surface. 3. Carefully pour fuel into the tank. Avoid spillage. 4. Prior to replacing the fuel cap, clean and inspect the gasket. 5. Immediately replace fuel cap and hand tighten. Wipe up any fuel spillage. NOTE: It is normal for smoke to be emitted from a new engine after first use. WARNING: Always shut off engine before fueling. Never add fuel to a machine with a running or hot engine. Move at least 30 ft. (9 m) from refueling site before starting engine. Do not smoke! PREMIUM EXACT MIX (50:1) GASOLINE OIL 1 gallon (US) 2.6 oz. 1 Liter 20 cc (20 ml) Fig. 8 OPERAT...

Scarica la tua

Per scaricare, digitare 2 cifre :