valutazioni - 5, GPA: 4.2 ( )

Produttore : Graco File Size : 353.49 kb File Nome : Lingua di insegnamento:

. Follow Pressure Relief Procedure on page 5 if the spray tip clogs and before you clean, check, or service this equipment. . Repair or replace worn or damaged parts immediately. . Check hoses, tubes, and couplings daily. Do not repair high-pressure couplings; you must replace the entire hose. Fluid hoses must have spring guards on both ends to prevent kinks and rupture. 2 308524 WARNING MOVING PARTS HAZARD Moving parts, such as the drive belt, can pinch or amputate fingers. . Keep clear of moving parts when you start or operate this equipment. . Do not operate the pressure washer without all guards and interlocks installed and functioning. HAZARDOUS FLUIDS Improper handling of hazardous fluids can cause serious injury or death from splashing in the eyes, ingestion, or bodily contamination. . Know the specific hazards of the fluid being used. . Wear protective eye wear, gloves, clothing, and respirator as recommended by the fluid and solvent manufacturer. . Store hazardous fluids in approved containers. Dispose of hazardous fluids per local, state, and national guidelines. FUEL HAZARD The fuel used in this pressure washer is combustible. When spilled on a hot surface, it can ignite and cause a fire. Do not fill the fuel tank while the engine is running or hot. EXHAUST HAZARD The exhaust contains poisonous carbon monoxide, which is colorless and odorless. Do not operate this equipment in a closed building. . Do not alter the throttle setting. EQUIPMENT MISUSE HAZARD Misuse of the pressure washer or accessories may cause them to rupture and result in fluid injection, splashing in the eyes or on the skin, or other serious injury. . Do not alter or modify any part or factory-set adjustment of this equipment. . Do not exceed the maximum working pressure of any component or accessory in the system. . Do not use any chemicals that are incompatible with the wetted parts as stated in the Technical Data on page 15. 308524 3 4 308524 Setup high-pressure hose connection hose rack inlet water connection 3/4” garden hose gun hose TI1262A Check for Shipping Damage Check the pressure washer for shipping damage. If anything is damaged, notify the carrier immediately. Set Up Connect the high-pressure hose between the pump outlet and the gun inlet. Both of these connections are made with quick couplers. CAUTION Up to 100 ft (30 m) of high-pressure hose may be used. Longer hoses may affect sprayer and chemical injector performance. Install the appropriate spray tip on the wand. See Installing and Changing Spray Tips on page 6. If you use a sandblaster kit, see its separate manual for installation instructions. Connect to Water Supply CAUTION Before you connect to the water supply, check your local plumbing code regarding cross connection to the water supply. Backflow Preventer 801133 is available to prevent backflow of contaminated water into the fresh water supply. Install it upstream from the pump. If inlet water pressure is over 60 psi (414 kPa, 4.1 bar) Regulati...

Scarica la tua

Per scaricare, digitare 2 cifre :