valutazioni - 2, GPA: 4
(
)
)
|
Facilità d'uso
. . . . . . . . . . . . . . . . . . . . . . 38 cm (15") full square type [35 cm (13.8") viewable] Flat face 90. deflection 0.28 Dot pitch Anti-reflection coating with Anti-electrostatic Medium short persistence phosphor Synchronization . . . . . . . . . . . . . . . . . . . . Horizontal: 30 kHz to 70 kHz (automatic) Vertical: 50 Hz to 120 Hz (automatic) Maximum Resolution . . . . . . . . . . . . . . . Horizontal: 1280 dots @ 64 kHz Vertical: 1024 lines @ 60 Hz Active Display . . . . . . . . . . . . . . . . . . . . . Horizontal: 267 ± 3 mm (10.5" ± 0.12") Vertical: 200 ± 3 mm (7.87" ± 0.12") (Active display size is dependent upon signal timing) Input Signal, Terminated . . . . . . . . . . . . . Analog video 0.714 Vpp positive at 75 W Separate sync: TTL level, positive or negative Maximum Pixel Clock . . . . . . . . . . . . . . . 110 MHz Power Supply. . . . . . . . . . . . . . . . . . . . . . AC 100-240 Volt ± 10%, 60 Hz/50 Hz ± 3 Hz Power Consumption . . . . . . . . . . . . . . . . 85 W (maximum), 75 W (nominal) BTUs . . . . . . . . . . . . . . . . . . . . . . . . . . . . Heat Release per Hour : 255.91 BTU/Hr Dimensions/Weight. . . . . . . . . . . . . . . . . Unit: 370 x 395 x 377 mm; 12.5 kg 14.6 x 15.6 x14.8 in (W x D x H); 27.6 lb Carton: 454 x 497 x 433 mm; 14.3 kg 17.9 x 19.6 x 17.0 in (W x D x H); 31.5 lb (All measurements approximate.) Environmental Considerations. . . . . . . . . Operating Temperature: 32°F to 104°F (0°C to 40°C) Humidity: 10% to 80% Storage Temperature: -4°F to 149°F (-20°C to 65°C) Humidity: 5% to 95% NOTE: Design and specifications are subject to change without prior notice. 1-12 Dell® 800F Series, 828FI Monitor User’s Guide E828fiW.book Page 13 Thursday, July 2, 1998 7:51 PM Pin Assignments Sync Type: Separate 15-Pin Side of the Signal Cable Pin No. 1 Red 2 Green 3 Blue 4 GND 5 DDC Return 6 GND-R 7 GND-G 8 GND-B 9 Reserved 10 GND-Sync/Self-Raster 11 GND 12 DDC Data 13 H-Sync 14 V-Sync 15 DDC Clock Display Resolution For optimal monitor performance while using MicrosoftO WindowsO 95 or Windows NT®, set the display resolution to 800 x 600 as follows : 1. Click the Start button, point to Settings, and click Control Panel. 2. Double-click the Display icon in the Control Panel window, and then click the Settings tab. 3. In the Desktop area, move the slidebar to 800 by 600 pixels, then click OK. Preset Timing Modes Horizontal Vertical Frequency Frequency Pixel Clock Sync Polarity Display Mode (kHz) (Hz) (MHz) (H/V) IBM®, VGA2, 720 x 400 31.469 70.087 28.322 -/+ IBM®, VGA3, 640 x 480 31.469 59.940 25.175 -/- VESA®, 640 x 480 37.500 75.000 31.500 -/- VESA®, 640 x 480 43.269 85.008 36.000 -/- VESA®, 800 x 600 46.875 75.000 49.500 +/+ VESA®, 800 x 600 53.674 85.061 56.250 +/+ VESA®, 1024 x 768 60.023 75.029 78.750 +/+ VESA®, 1024 x 768 68.677 84.997 94.500 +/+ Dell® 800F Series, 828FI Monitor User’s Guide 1-13 E828fiW.book Page 14 Thursday, July 2, 1998 7:51 PM Regulatory Notices and Warranties Electric and Magnetic Fields Energy Efficiency The proper operation of the function requires a computer with VESA DPMS power management capabilities. When used with a computer equipped with VESA DPMS, the monitor is ENERGY STAR compliant. Federal Communications Commission (FCC) Notice (U.S. Only) Class B Notice This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the manufacturer's instruction manual, may cause harmful interference with radio and television reception. This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of these measures: • Reorient or relocate receiving antenna. • Relocate the equipment with respect to the receiver. • Move the equipment away from the receiver. • Plug the equipment into a different outlet so that the equipment and receiver are on different branch circuits. If necessary, consult a representative of Dell Computer Corporation or an experienced radio/television technician for additional suggestions. You may find the following booklet helpful: FCC Interference Handbook, 1986, available from the U.S. Government Printing Office, Washington, DC 20402, Stock No. 004-000-00450-7. Note that FCC regulations provide that changes or modifications not expressly approved by Dell Computer Corporation could void your authority to operate this equipment. A Notice About Shielded Cables: Use only shielded cables for connecting peripherals to any Dell device to reduce the possibility of interference with radio and telev...
Questo manuale è adatto anche per i modelli :Monitor - 800F (1.02 mb)