valutazioni - 4, GPA: 4.3
(
)
)
|
Facilità d'uso
Total lighting load including lamp- heads on fixture(s) must not exceed 500W (4.2A). Junction Box Lamp Holders CAUTION: Do not mount the sensor above or touching the lamps. Keep regular PAR-38 lamps at least 1" (25 mm) from the sensor. Halogen lamps should be kept at least 2" (51 mm) from the sensor. The sensor bottom must be facing down for best coverage and to avoid water damage and electrical shock. Note: For under-eave installation, rotate the sensor head 180° by bending the sensor towards the clamp bracket. Rotate the sensor bottom clockwise away from the bracket. 4. Operation For motion sensing, put the ON-TIME switch on the bottom of thesensorinthe 1,5,or 20minute position.Whenmotionis detected, the lights will come on the selected time. Note: The photocell keeps the lights from turning on in daylight. To keep lights on all night, flip the light switch off for 1 second then back on. To return the sensor to the motion sensing mode, flip the light switch off for 1 second then back on. At dawn, the control will return to the motion sensing mode and shut off. For accent lighting, set the DUALBRITE® switch to the 3, 6, or Dusk-to-Dawn setting. The lights will turn on dim at sundown for the set time. When motion is sensed the lights will turn on full bright for the set ON-TIME period. The lights will return to dim during the set DUALBRITE® period. Specifications: Total Lighting Wattage.. Up to 500 Watts Maximum Incandescent Range .........................up to 70 ft.; up to 100 ft. with Range Boost Time Delay........................................................1, 5, or 20 minutes DUALBRITE® ....................................Off, 3, 6 hours, Dusk-to-Dawn CAUTION:This product is to be used with a U.L.listed rain tight or wet location suitable outlet box.Depending on the installation, additional hardware may be required. © 2005 598-1231-00 Reemplazo de la cabeza del detector DUALBRITE® Modelos 3009701 / 3209996 Nota:Lainstalaciondeestecontroldeluzdebeserhechasoloporpersonas con experiencia en cableados de casa con 120 voltios. Instale segun las normas locales.Algunoscodigoslocalespuedenexigirquelainstalacion de este control de luz sea hecha por un electricista certificado. 2. Luego de atornillar el detector a la placa de pared, conecte los alambres de la caja de empalme a los alambres de control de la lampara como se muestra en la figura 1: •El alambre NEGRO del detector con el alambre NEGRO (CALIENTE) de la casa. •El alambre blanco del detector a todos los alambres blancos (NEUTROS) de la vivienda y de la lampara. •El alambre rojo (DE RETORNO) del detector a los alambres negros de la lampara. 3. Monte su aparato de luz de acuerdo a las instrucciones que vienen con el mismo. Figura 1 - Cableado de la cabeza del detector Alambre NEGRO del de- tector con alambre NEGRO de la caja de empalmes Todos Los Alambres BLANCOS Alambre ROJO con alambres NEGROS Opcional: Conecte una carga adicional (otra lampara) a los alambres blanco y rojo del detector. L...
Questo manuale è adatto anche per i modelli :Monitor - DUALBRITE 3209996 (254.75 kb)