valutazioni - 2, GPA: 4
(
)
)
|
Facilità d'uso
These buttons are connected to the temperature display. • The temperature display is switched over from the display of the ACTUAL temperature (Temperature display is illuminated) to the display of the DESIRED temperature (Temperature display flashes) by pressing one of the two buttons, „+“ (WARMER) or „-“ (COLDER). • Each time one of the two buttons is pressed again the DESIRED temperature is adjusted by 1 °C. • If neither button is pressed, the temperature display automatically switches back after a short period (approx. 5 sec.) to the display of the ACTUAL temperature. The ACTUAL temperature in the appliance is now adjusted to match the preset DESIRED temperature. DESIRED temperature means: The temperature that is required in the appliance, this can be adjusted to the temperatures shown in the display. The DESIRED temperature is indicated by flashing numbers. ACTUAL temperature means: The temperature display indicates the temperature that is currently present in the appliance. The ACTUAL temperature is indicated with illuminated numbers. 3 Once the FROSTMATIC function has been switched on the DESIRED temperature that was set originally cannot be changed. 818 35 95-01/9 Description of the appliance Temperature display The temperature display shows several types of information. • In normal operation the current freezer compartment temperature is displayed (ACTUAL temperature). • During temperature adjustment, a flashing display of the temperature selected at the moment occurs (DESIRED temperature). • In the event that frozen food has been partially or totally defrosted, perhaps as the result of a lengthy power failure and if the ALARM OFF button is activated the temperature display will show the warmest temperature the frozen food has reached on restoration of the power supply. • If there is a fault in the appliance a square will appear in the temperature display. FROSTMATIC-button The FROSTMATIC function provides for quick freezing of fresh food products, and at the same time protects previously stored goods against undesired warming in the freezer compartment. 0 1. The FROSTMATIC function is switched on by pressing the FROSTMATIC button. The yellow light illuminates. The compressor runs continuously. 2. The FROSTMATIC function can be ended manually at any time by pressing the FROSTMATIC button again. The yellow light goes out. If the FROSTMATIC function is not ended manually, the appliance electronics switch off the FROSTMATIC function after approx. 50 hours. The yellow light goes out. Important! Once the FROSTMATIC function has been switched on the DESIRED temperature that was set originally cannot be changed. ALARM OFF button With the ALARM OFF button, the acoustic warning signal can be switched off, e.g. the "Open Door" warning when sorting in or out, the food to be frozen. When there is a temperature warning, if the ALARM OFF button is activated, the temperature display will show the warmest temperature the frozen food has reached. 818 35 95-01/9 Prior to Initial Start–Up 1 Before connecting the appliance to the mains and putting it into operation for the first time, leave the appliance to stand for 30 minutes if was transported upright. After transport on its side, the appliance must be left to stand for 2 hours before putting it into operation. This is necessary to allow the refrigerant to flow back into the compressor. Otherwise the compressor may be damaged. 0 1. Please clean the appliance interior and all accessories prior to initial start-up (see section: “Maintenance and Cleaning”). 2. The appliance must be correctly installed in accordance with the chapter "Installation" before it is put into operation for the first time. Care should be especially taken that the mains voltage and frequency available correspond with the appliance’s rating plate. 3. Remove the cold accumulation block from the appliance. 4. Only put the cold accumulation block to freeze in the top compartment after the optimal storage temperature of –18 °C has been reached. 5. After 24 hours place the cold accumulation block in the uppermost compartment, at the front, above the frozen food. 6. Re-freeze the thawed cold accumulation block in the same way, e. g. after cleaning the appliance. Initial use 0 1. Insert plug into mains socket. 2. Press the ON/OFF button. A warning tone sounds and the red warning light flashes indicating that the required storage temperature has not yet been reached. 3. Press the ALARM OFF button to switch off the warning tone. 4. Set temperature to -18°C or colder (see section: "Temperature Adjustment"). Important! Wait until the freezer compartment has reached a temperature of –18 °C, or the red warning light has gone out, before storing frozen food. 818 35 95-01/9 Temperature Adjustment 0 1. Press either the „+“ (WARMER) or „-“ (COLDER) button. The temperature display switches over and the DESIRED temperature currently set flashes on the temperature display. 2. To adjust to a warmer temperature, press...
Questo manuale è adatto anche per i modelli :congelatori - ARCTIS 75248 GA1 (199.67 kb)