valutazioni - 3, GPA: 4.3
(
)
)
|
Facilità d'uso
• If audio tracks and images in music CD format or video CD format are recorded in the first session, only the first session will be played back. Copyrights This product incorporates copyright protection technology that is protected by U.S. patents and other intellectual property rights. Use of this copyright protection technology must be authorized by Macrovision, and is intended for home and other limited viewing uses only unless otherwise authorized by Macrovision. Reverse engineering or disassembly is prohibited. 7GB Getting Started Hooking up the system Perform the following procedures 1 to 4 to hook up your system using the supplied cords and accessories. AM loop antenna To center speaker To front speaker (left) FM lead antenna To front speaker (right) To surround speaker (right) To surround speaker (left) To subwoofer 1 Connect the speakers. Be sure to match the appropriate speaker cords from the speaker terminals to the corresponding SPEAKER terminals on the unit. Connect Terminal Front speakers SPEAKER FRONT L(white)/R (red) Surround SPEAKER SURR L (blue)/ speakers R (gray) Center speaker SPEAKER CENTER (green) Subwoofer SPEAKER WOOFER (purple) Speakers Black (#) Gray (3) Black (#) Gray (3) 8GB Notes 3 Connect the t INPUT jack of your TV • When inserting the speaker cord plugs into the SPEAKER terminals on the unit, press in the plugs all the way until they click. When unplugging the speaker cords, press the protrusions on the plugs and pull out the plugs. • Keep the speaker cords away from the antennas to prevent noise. • Do not place the surround speakers on top of a TV. This may cause distortion of the colors in the TV screen. • Be sure to connect both left and right surround speakers. Otherwise, the sound will not be heard. Tip When positioning the front speakers higher than floor level, using the speaker stand WS-MC1 (not supplied) is convenient. 2 Connect the FM and AM antennas. Set up the AM loop antenna, then connect it. AM loop antenna to the T LINE-TV jack on the unit with the SCART cord (not supplied). When you connect using the SCART cord, check that the TV conforms to S video or RGB signals. If the TV conforms to S video, change the input mode of the TV to RGB signals. Refer to the operating instructions supplied with the TV to be connected. When using a TV Turn on the TV and select the video input so that you can view the pictures from this system. When connecting a video deck Connect the TV and the video deck using video and audio cords (not supplied) as shown below. Getting Started Extend the FM lead antenna horizontally TV Video deck System Do not connect directly. If you connect a video deck between this system and the TV, you may experience video leakage when watching the video signal from this system. Do not connect a video deck between this system and the TV. Note Do not place the TV on this system. Tip To listen to TV, press FUNCTION repeatedly to select “TV”. continued 9GB 4 Connect the mains lead to mains. If the plug does not fit your wall socket, detach it from the plug (only for models equipped with an adapter). To turn on the system, press ?/1. Note When you turn on the system, the disc is not pulled into the disc slot until “No Disc” appears in the display. Do not attempt to push in the disc until “No Disc” appears, as this may cause malfunction. See page 51. Inserting tw Notes • If you do not use the remote for a long period of time, remove the batteries to avoid possible damage from battery leakage and corrosion. • See page 71 for the location of the remote sensor. Tip With normal use, the batteries should last for about six months. When the remote no longer operates the system, replace both batteries with new ones. Using the remote control • Select the item with v/V/b/B and press the center to enter the selection. In this operation manual, the operation “press the center to enter the selection” is expressed as “press ENTER”. • Normally operate the remote with the cover closed. Open the cover only when operating the buttons inside the cover. Press the center to enter the selection (ENTER button). Front cover 10GB Positioning the speakers 1 Place the front speakers at an angle of 45 degrees from your listening position. Center speaker Front Front speaker speaker (L) (R) Subwoofer Surround speaker Surround speaker (L) (R) 2 Place the center speaker at about the same height as the front speakers. Align the center speaker with the front speakers or place it slightly behind the front speakers. 3 Place the surround speakers. 20° Position the surround speakers within the respective gray ranges. Positioning both surround speakers the same distance from the listening position is effective. 4 Place the subwoofer. To obtain a better bass reproduction, we recommend you to place the subwoofer on a solid floor where resonance is unlikely to occur. Notes • Do not place the surround speakers on top of a TV. This may cause distortion of the colors in the TV screen. • Always place the ...