valutazioni - 4, GPA: 4
(
)
)
|
da questo dispositivo ha anche altre istruzioni :
Facilità d'uso
The disc tray does not close. • Place the disc correctly. • Always close the tray by pressing Z on the unit. Trying to press the tray closed with your fingers may cause problems with the player. The disc does not eject. • You cannot eject the disc during CD Synchro Recording. Press x to cancel the CD Synchro Recording, then press Z on the unit to eject the disc. • Consult your nearest Sony dealer. Play does not start. • Open the disc tray and check whether a disc is loaded. • Wipe the disc clean (page 29). • Replace the disc. • Place the disc that this system can play (page 4). • Place the disc correctly. • Place the disc in the tray with the label side up. • Remove the disc and wipe away the moisture on the disc, then leave the system turned on for a few hours until the moisture evaporates. •Press N to start play. The sound skips. • Wipe the disc clean (page 29). • Replace the disc. • Try moving the system to a place without vibration (e.g., on top of a stable stand). • Try moving the speakers away from the system, or placing them on separate stands. When you listen to a track with bass sounds at high volume, the speaker vibration may cause the sound to skip. Play does not start from the first track. • Press PLAY MODE repeatedly until both “PGM” and “SHUF” disappear to return to Normal Play. MP3 audio track cannot be played back.* • Recording was not performed according to the ISO 9660 level 1 or level 2 format, Joliet or Romeo in the expansion format. • The MP3 audio track does not have the extension “.MP3”. • The data is not stored in MP3 format. • Discs containing files other than MPEG 1 Audio Layer-3 files cannot be played. MP3 audio tracks take longer to play back than others.* • After the system reads all tracks on the discs, playback may take more time than usual if: – the number of albums or tracks on the disc is very large. – the album and track organization structure is very complex. The album title, track title and ID3 tag do not appear correctly.* • Use a disc that conforms with ISO 9660 level 1, level 2, Joliet or Romeo in the expansion format. • The disc ID3 tag is not ver. 1 (ver. 1.0 or 1.1). * MHC-GX45/GX35/RG440S/RG330/RG310 and MHC-RG220 (European and Russian models) only Tuner Severe hum or noise/stations cannot be received. • Set the proper band and frequency (page 13). • Connect the antenna properly (page 7). • Find a place and an orientation that provide good reception, then set up the antenna again. If you cannot obtain good reception, we recommend you connect a commercially available external antenna. • The supplied FM lead antenna receives signals along its entire length, so make sure you extend it fully. • Locate the antennas as far away from the speaker cords as possible. • Try turning off surrounding electrical equipment. Troubleshooting continued 27GB A stereo FM program cannot be received in stereo. • Press FM MODE (or STEREO/MONO for MHCGX25 and MHC-RG220 (except for European and Russian models)) until “MONO” disappears. Tape deck The tape does not record or play, or there is a decrease in sound level. • The heads are dirty. Clean them (page 30). • The record/playback heads are magnetised. Demagnetise them (page 30). The tape does not erase completely. • The record/playback heads are magnetised. Demagnetise them (page 30). There is excessive wow or flutter, or the sound drops out. • The capstans or pinch rollers are dirty. Clean them (page 30). Noise increases or the high frequencies are erased. • The record/playback heads are magnetised. Demagnetise them (page 30). The tape does not record. • No cassette is loaded. Load a cassette. • The tab has been removed from the cassette. Cover the broken tab with adhesive tape (page 30). • The tape has wound to the end. If the system still does not operate properly after performing the above measures, reset the system as follows: 1 Disconnect the power cord. 2 Reconnect the power cord. 3 Press x, GROOVE and ?/1 at the same time. 4 Press ?/1 to turn on the system. The system is reset to the factory settings. You should set the settings you made, such as the preset stations, clock, and timer. Messages One of the following messages may appear or flash in the display during operation. CD/MP3 NO DISC There is no disc in the player. OVER You have reached the end of the disc while pressing M during playback or pause. 28GB Additional Information Precautions On operating voltage Before operating the system, check that the operating voltage of your system is identical with the voltage of your local power supply. On safety • The unit is not disconnected from the AC power source (mains) as long as it is connected to the wall outlet, even if the unit itself has been turned off. • Unplug the system from the wall outlet (mains) if it is not to be used for an extended period of time. To disconnect the power cord (mains lead), pull it out by the plug. Never pull the cord itself. • Should any solid object or liquid fall into the system, unplug the syst...
Questo manuale è adatto anche per i modelli :Stereo - MHC-GX35 (412.53 kb)
Stereo - MHC-GX45 (412.53 kb)
Stereo - MHC-RG220 (412.53 kb)
Stereo - MHC-RG310 (412.53 kb)