valutazioni - 2, GPA: 5
(
)
)
|
Facilità d'uso
20. HIGH-Z LINE: Use these jacks to connect the output signal from a stereo line level source (such as a stereo instrument, rhythm machine, tape deck, etc.) to the mixer by means of shielded cables terminated with male 1/4” plugs. Tip = “+,” ring = “–,” sleeve = shield. The LEFT (MONO) jack serves as a mono input that will feed a single input signal to both the left and right channels. For stereo signals, use the LEFT (MONO) jack as the left channel input and the RIGHT jack as the right channel input. 21. MIC: Use this jack to connect the output signal from a low impedance microphone to the mixer by means of a shielded cable terminated with a male XLR plug. Pin 2 = “+,” pin 3 = “–,” pin 1 = shield. The Master Section: 22 23 32 34 42 40 41 43 44 45 46 47 35 36 37 24 30 28 38 39 29 25 31 26 27 33 6 PM62S/PM82S/PM82T Powered Mixers 22. DSP ON: This switch, when depressed, activates the internal digital signal processor. 23. PROGRAM: Use this rotary switch to select the desired digital effect. The name of the selected effect illuminates on the DSP display panel (located above the On switch, #22). A brief description of the DSP effects is provided on page 9. 24. MONITOR: Use this seven band graphic equalizer to shape the monitor output signal. This is useful for feedback control and to compensate for room acoustics. 25. LIMITER/LED METER: The mixer employs internal limiter circuits to prevent overdrive distortion from being reproduced by the amplifiers. The Limiter LED illuminates when the monitor amplifier’s internal limiter circuit is activated. The five-step LED display directly below the Limiter LED indicates the level of the monitor’s output signal. 26. POWER LED: This LED will illuminate when the mixer is turned on. (The power switch is located on the mixer’s rear panel - see #51, page 9.) 27. PHANTOM POWER: This switch, when at the “on” position, applies +48 volts DC to pins 2 and 3 of each channel’s XLR MIC input jack. The adjacent LED illuminates when the phantom power is turned on. 28. EFF RET LEVEL: Use this control to adjust the level of the internal DSP applied to the signal at the Monitor Out jack (#47) and the Speakers - Monitor jacks (PM82T only - #50, page 9). 29. MONITOR LEVEL: Use this control to adjust the overall level of the signal at the Monitor Out jack (#47) and the Speakers - Monitor jacks (PM82T only - #50, page 9). 30. MAIN: Use this seven band graphic equalizer to shape the main output signal. This is useful for feedback control and to compensate for room acoustics. Each slider controls both main outputs simultaneously (see Speakers - Left / Right, #48 on page 9). PM62S/PM82S/PM82T Powered Mixers The Master Section (con’t): 31. LIMITER/LED METER: The mixer employs internal limiter circuits to prevent overdrive distortion from being reproduced by the amplifiers. The Limiter LEDs illuminate when either of the main amplifiers’ internal limiter circuits are activated. The two sets of five-step LE...
Questo manuale è adatto anche per i modelli :Strumenti Musicali - PM82T (775.16 kb)
Strumenti Musicali - PM62S (775.16 kb)