valutazioni - 3, GPA: 4
(
)
)
|
Facilità d'uso
or vocal mixer 'l V“iôô!ooiô;-, ' VoooO'O, UAalHiu. j (1) Input Section The VU meter indicates echo output level. As the needle approaches 'O', echo distortion and noise will decrease. For normal use> set the level so that the needle fluctuates between '—3' and 'O'. Mic Volume Instrument Volume Q These independent 3-channel controls are used to vary mic and instrument recording levels when they are connected directly to the RE-101. Two microphones and one instrument can be controlled and mixed simultaneously. For best echo effect balance adjust them (© ©0) so that VU meter (0) needle fluctuates between '—3' and 'O'. Note: When connecting to P.A. or vocal mixer (refer to connection diagram A at left), input adjustments should be controlled by mixer's effect controls. (2) Echo Effect Section Mode Selector Controls echo interval by switching different playback heads in and out 6 different modes are available divided into 3 "R EPEAT" modes (simple repeat-only effect) which are produced by switching of 3 of the playback heads and 3 "SWELL" modes (rich and complex effect) which are produced by com-binating all playback heads in different ways. * Mode Selector Position Intensity Controls intensity of echo repetition. Turn counterclockwise to lessen intensity. When set above 6—7, echo will not fade but will begin to oscillate. For maximum volume without howling, adjust level to the point just before oscillation starts. REPEAT SWELL 1 2 3 4 5 6 Playback Heads 1 ■> 2 3 Repeat Rate © justment of tape speed, each of the six different modes of the mode selector ( © ) can be further modified. Normally, set the. control in the center position and adjust for desired sound "color" when necessary. Turn it counterclockwise to lengthen interval. Echo Volume 0 Controls amount of echo contained in the total output. At "STRAIGHT”, the original sound appears at the output with no echo; turning the controi clock wise gradually adds echo to the output sound without affecting the level of the original sound. j • For most uses set REPEAT < RATE ( 0 ), INTENSITY ( O ) \ and ECHO VOLUME ( © ) at '5' J as shown in the figure and then i adjust each for desired sound. ! • The total output level of the I RE-101 is controlled by the change-| over switch ( © ) next to the OUT j PUT jack ( © ), and by the volume \ controls on. the external amp or ! mixer used with the RE-101. (3) Connections From P.A. Input Q This is used for connection of jack from TO ECHO to PA Mixer or Vocal Mixer (fig. A) (From Green WASHER to Green WASHER). Mic Input