valutazioni - 4, GPA: 4.3
(
)
)
|
Facilità d'uso
* Once the connections have been completed (p. 8), turn on power to your various devices in the order specified. By turning on devices in the wrong order, you risk causing malfunction and/or damage to speakers and other devices. When powering up: Turn on the power to your guitar amp last. When powering down: Turn off the power to your guitar amp first. * Always make sure to have the volume level turned down before switching on power. Even with the volume all the way down, you may still hear some sound when the power is switched on, but this is normal, and does not indicate a malfunction. * When operating on battery power only, the unit’s indicator will become dim when battery power gets too low. Replace the battery as soon as possible. Operating the Unit 5432 1. When you have made the necessary connections (p. 8), depress the pedal switch to turn the effect on. (the CHECK indicator turns red.) * The unit’s functions differ according to how it is connected. Refer to “Outputting Only the Effect” (p. 11). 2. Select the mode with the MODE switch. 3. Adjust the reverb time with the TIME knob. 4. Adjust the tone of the reverb sound with the TONE knob. 5. Adjust the effect volume level with the E.LEVEL knob. Outputting Only the Effect By plugging into INPUT-B, you can have only the effect sound be output (the direct sound is not output). * When the effect is off, the output from OUTPUT-A and OUTPUT-B is muted. Mixer RETURNRETURNSEND SEND Guitar Amplifier * Make sure the input/output levels of devices being connected are matched appropriately. * When using a guitar amp to send/return the direct sound as well, connect to INPUT-A (MONO). Changing the Battery When the indicator goes dim or no longer lights while an effect is on, it means that the battery is nearly dead and must be replaced. Replace the battery following the steps below. * The use of an AC adaptor is recommended as the unit’s power consumption is relatively high. Should you prefer to use batteries, please use the alkaline type. Thumbscrew Pedal Spring Base Battery Snap Cord Coil Spring Guide Bush Hole Battery Snap Battery Housing 9V Battery 1. Loosen the thumbscrew at the front of the pedal, then lift the pedal upwards to open the unit. * The thumbscrew can be left in the pedal while changing the battery. 2. Remove the old battery from the battery housing, and remove the snap cord connected to it. 3. Connect the snap cord to the new battery, and place the battery inside the battery housing. * Be sure to carefully observe the battery’s polarity (+ versus –). 4. Slip the coil spring onto the spring base on the back of the pedal, then close the pedal. * Carefully avoid getting the snap cord caught in the pedal, coil spring and battery housing. 5. Finally, insert the thumbscrew into the guide bush hole and fasten it securely. Troubleshooting Power won’t come on / CHECK indicator doesn’t ...
Questo manuale è adatto anche per i modelli :Strumenti Musicali - Boss RV-5 (601.47 kb)