valutazioni - 1, GPA: 3
(
)
)
|
Facilità d'uso
Troubleshooting Troubleshooting Power won’t come on / . Is your bass guitar properly connected to CHECK indicator doesn’t light: the INPUT jack? Check the connection once more (p. 8). . Is the specified adaptor (PSA-series; * To prevent useless depletion of the battery when the sold separately) properly connected? unit is running on battery power, the power is Check the connection once more (p. 8). switched on only when a cable is plugged in to the * Never use any AC adapter other than one specified INPUT jack. for use with the SYB-5. * The CHECK indicator shows whether the effect is . Is the battery low or dead? being applied or not. It does not indicate whether the power to the device is on or not. Replace with a new battery (p. 18). * The battery that was supplied with the unit is for temporary use, intended primarily for testing its operation. * The use of an AC adaptor is recommended as the unit's power consumption is relatively high. Should you prefer to use batteries, please use the alkaline type. Troubleshooting No sound / Low volume: . Is the SYB-5 properly connected to your instrument? Check the connection once more (p. 8). . Is the volume turned down on any bass amp or effects device you have connected? Check the settings of the connected device. . Is OUTPUT B connected? Sounds are output only from the OUTPUT B jack when the effect is switched off while a plug is connected to the OUTPUT B jack. When the effect is off, the output from the OUTPUT A (MONO) jack is muted, with no sounds being output. Sound is distorted: . Is the battery low? As the battery is drained, the CHECK indicator dims, and the SYB-5 may start to function incorrectly. Replace with a new battery (p. 18). * The battery that was supplied with the unit is for temporary use, intended primarily for testing its operation. * The use of an AC adaptor is recommended as the unit's power consumption is relatively high. Should you prefer to use batteries, please use the alkaline type. . Could the level of the sound being input be excessive? With some bass guitars, distortion may be produced. Be careful of your bass guitar’s output level. Troubleshooting Effect sounds, filter motion not stable . Do you have a device other than a bass guitar (such as an effects processor) connected to the INPUT jack? To ensure stability of the sound information input to the SYB-5, do not connect other effects devices to the INPUT jack. Connect the bass directly to the SYB-5. When a guitar or other electric or electronic musical instrument is connected here, the pitch (the range for detecting pitch is A0–C5) is not detected correctly. . Are you playing chords with the SYB-5 set to an internal sound mode (MODE 1–9)? The internal sound modes (MODE 1–9) feature effects meant for use only with single notes. When chords are to be input, use Wave Shape Mode. . Have you increased (boosted) the volume level of a specific frequency range with a knob on your bass? Boosting the volume of a specific frequency range using the bass knobs may prevent stable operation of the SYB-5. To ensure stable functioning, adjust the knobs on your bass so the volume levels for all frequency ranges are flat. Setting Samples Setting Samples SAW WAVE SQUARE WAVE SLOW AUTO FILTER FAT SOUND Setting Samples TALKING PULSE WIDTH MODULATION DEEP FILTER SWEEP Setting Memo Setting Memo Specifications Specifications SYB-5: Bass Synthesizer Nominal Input Level..................... -20 dBu Input Impedance............................ 1 M. Nominal Output Level.................. -20 dBu Output Impedance ........................ 1 k. Recommended Load Impedance ...... 10 k. or greater Residual Noise ............................... -96 dBu (IHF-A, Typ.); All knobs at center position Controls........................................... Pedal switch, EFFECT knob, DIRECT knob, FREQ knob, RES knob, DECAY/RATE knob, MODE knob Indicators ........................................ CHECK indicator (Serves also as battery check indicator) Connectors...................................... INPUT jack, OUTPUT A (MONO) jack, OUTPUT B jack, EXP jack, AC adaptor jack (DC 9 V) Power Supply................................. DC 9 V: Dry battery/9 V type (6F22 (carbon), 6LR61 (alkaline)), AC Adaptor (PSA-series: optional) Specifications Current Draw ................................. 50 mA (DC 9 V) * Expected battery life under continuous use: Carbon: 2 hours, Alkaline: 6 hours These figures will vary depending on the actual conditions of use. Dimensions..................................... 73 (W) x 129 (D) x 59 (H) mm 2-7/8 (W) x 5-1/8 (D) x 2-3/8 (H) inches Weight ............................................. 440 g /1 lb (including battery) Accessories...................................... Owner’s Manual, Mode Label, Leaflet (“USING THE UNIT SAFELY,” “IMPORTANT NOTES,” and “Information”), Dry battery/9 V type (6LR61) * The battery that was supplied with the unit is for temporary use- intended primarily for testing its operation....