valutazioni - 3, GPA: 4
(
)
)
|
da questo dispositivo ha anche altre istruzioni :
Facilità d'uso
¦ Assembly Bb/A Clarinet 1. Attach the barrel to the upper joint and the bell to the lower joint. 2. To link the upper and lower joint bridge keys together, hold the upper joint in your left hand as shown in the illustration and press the upper keys to raise the bridge key. 3. Hold the lower joint in your right hand and check the position of the bridge key. Slide the lower joint onto the upper joint by rotating the lower joint. * Make sure the upper and lower bridge keys do not come into contact with each other. 4. After connecting the upper and lower joints together, attach the mouthpiece. Eb Clarinet 1. Attach the barrel and bell to the main body. 2. Attach the mouthpiece to the barrel. bridge key Assembl y Alto Clarinet / Bass Clarinet Caution When Assembling As bridge keys protrude from the neck, upper joint, lower joint, and bell on the alto and bass clarinets, be careful not to damage or bend these parts when assem- bling the instrument. The bell section and tone hole on the alto clarinet is thin so please use extra caution when assembling these parts. Bell bridge key 1. Attaching the bell to the lower joint. Holding the bottom of the bell in your right hand, slide the bell section partially onto the joint. 2. Hold down the pad plate on the bell with your right thumb then slide the bell all the way onto the joint. When assembling the bass clarinet, insert the peg at this point to provide stability when standing the instrument on the floor. 3. Assemble the upper and lower joints. While checking the position of the bridge keys, align the upper and lower bridge keys and slide the upper and lower joints together without twisting. * Make sure the upper and lower bridge keys do not come into contact with each other. 4. Attach the neck to the upper joint. . On the alto clarinet After attaching the mouthpiece to the neck, insert the neck into the upper joint. . On the bass clarinet Attach the lower and upper neck sections and secure them with the fastening screw. Next, attach the mouthpiece onto the upper neck and then the mouthpiece/neck assembly into the upper joint. Assembly ¦ Attaching the Reed 1. Soak the reed in your mouth or in some water. From the tip end of the mouthpiece, slide on the ligature as shown in the illustration. Reed Mouthpiece Ligature 2.Attach the reed to the mouthpiece. First, place the reed so that the tip of the mouthpiece is seen over the end of the reed then tighten the ligature screws to secure the reed. * After playing, use a piece of gauze to dry the reed, then store the reed in a reed case. As the reed and mouthpiece are easily dam- aged, always keep the mouthpiece covered with its cap when the instrument is not being played. Reed Ligature Screws Cap ¦ Tuning Since the temperature of the instrument effects its pitch, the instrument should first be warmed up before tuning by blowing air through it. . A, Bb, & Eb Clarinets Push in or pull out on the barrel to tune the clarinet. When the pitch is high. Barrel When the p...
Questo manuale è adatto anche per i modelli :Strumenti Musicali - YCL-681II (1.53 mb)
Strumenti Musicali - YCL-881 (1.53 mb)
Strumenti Musicali - YCL-250 (1.53 mb)
Strumenti Musicali - YCL-255 (1.53 mb)