valutazioni - 3, GPA: 4
(
)
)
|
da questo dispositivo ha anche altre istruzioni :
Facilità d'uso
Refer to the following website for its function in relation to trigger input jacks. 7 Connecting Using the stereo audio cable provided, connect the pad unit’s output to a suitable input jack on a DTX Series Drum Trigger Module. At this time, ensure that the L-shaped end of the cable is plugged into the pad unit’s OUTPUT connector. Adjusting Output Level (PCY135 and PCY155) Using a small screwdriver or a similar tool, you can turn the LEVEL adjustor q on your pad unit to adjust the level of trigger signals that it outputs. Turn clockwise to increase the level and vice-versa. Adjust the trigger signal to best suit the strength of your playing, your desired dynamic range, and the type of DTX Series Drum Trigger Module you are using. • If playing fortissimo (ff) passages with your pad unit connected to a DTX Series Drum Trigger Module, you should set the gain level on the module's Trigger Setup page such that the input level is indicated as being between 90% and 95%. For more details, refer to the Owner's Manual for your drum trigger module. Note that an excessively large output level can be the cause of problems such as restricted dynamic range (i.e., very little sensitivity to different playing strengths) and double triggering, where two distinct sounds are produced each time you hit the pad. • Applying excessive force to the LEVEL adjustor can result in breakage and should be avoided. OUTPUT PCY135/155 Setting the Cup Switch (PCY100) Located on the rear of the PCY100, the cup switch (CUP SW) determines whether the pad unit is to be used as a hi-hat (OFF) or a cymbal (ON). OUTPUT PCY100 CUP SW 8 Troubleshooting If you encounter any of the following difficulties when playing your PCY Series pad unit, please take the steps indicated to resolve them before ordering repairs. No Sound, Volume is Low • Is the pad connected to the correct input number of the DTX Series Drum Trigger Module using the supplied stereo phone cable? When a pad is connected with a mono phone cable, the voices assigned to the edge and cup sections are not produced. • If using a PCY135 or PCY155 pad unit, try increasing the LEVEL adjustor setting. (See “Adjusting Output Level (PCY135 and PCY155) ” on page 8 for more details.) Multiple sounds are produced each time the pad is hit (i.e., double triggering). • If using a PCY135 or PCY155 pad unit, try decreasing the LEVEL adjustor setting. When the level setting is too high, large trigger signals take longer to fade away, and the drum trigger module may interpret them as multiple signals in quick succession. (See “Adjusting Output Level (PCY135 and PCY155) ” on page 8 for more details.) Also, please refer to the...
Questo manuale è adatto anche per i modelli :Strumenti Musicali - PCY100 (2.94 mb)
Strumenti Musicali - PCY155 (2.94 mb)